Catalog excerpts
the cylinder pressure people for pressure control on engines The closed face makes the sensor immune to sooting. • Sensor desinged for diesel- and gas engines • Digital electronic with event storing • Very good thermodynamic performance Permanent installation for engine control
Open the catalog to page 1
Mounting The sensor should be installed close to the combustion chamber, the length of the pressure bore between sensor and combustion chamber depends mainly on engine speed. Generally there are two possibilities for the installation position of cylinder pressure sensors: Head mounted or set-back mounted. Head mounted installation Armored steel cable cable protection I = 1.0 m d = 7.0 mm Signal conditioning unit (SCU) Ml 2 male connector, A-coding SCU contact arrangement Ml 2 male connector, A-coding Pin 5: Programming pin only used for calibration Pin 4: Signal zero point AGND Welded...
Open the catalog to page 2All Imes catalogs and brochures
-
IPT-01HTKY2 Pages
-
TCS-01®3 Pages
-
TCS-01CA®3 Pages
-
FPS-01CA3 Pages
-
FPS-023 Pages
-
FPS-02CA3 Pages
-
SPS-012 Pages
-
IPT-01XHT2 Pages
-
BIF-BOX2 Pages
-
Protection cover1 Pages
-
EPM-XP2 Pages
-
IMES IPE2 Pages
-
EPM-XP plus2 Pages
-
EPM-Peak2 Pages
-
EPM-XG2 Pages
-
CCM Gas Engine control3 Pages
-
CCM Gas portable4 Pages
-
CCM Marine portable4 Pages
-
imes_sensor-brochure8 Pages
-
CPS -0 13 Pages
-
htt-051 Pages
-
HTT-04 ®3 Pages
-
HTT-04CA ®3 Pages
