AIRSAVE ULTIMATE - Proven Safety Anytime Anywhere CO2 flushing. ————— After replacement of a dryer cartridge there will be a higher CO2 concentration in the compressed breathing-air in the cartridge, because for a while the molecular sieve absorbs CO2 from the air and releases it back into the dryer cartridge when the pressure drops, e.g. because the compressor is switched off. When a IDEcompressor is started, this air with increased CO2 concentration is expelled from the filter housing. We recommend flushing the IDE compressor system for about 2 minutes to prevent air with increased CO2 concentration from entering into scuba cylinders. Open the flush valve to expel the contaminated air. Not all high pressure compressors of all manufacturers are equipped with flush valves, but our technicians can retrofit them. All IDE compressors have a - usually automatic - flushing system. If flushing does not improve the CO2 measurement within a few minutes the compressor will be stopped. In this case we recommend using our AIRSRUBBER CO2-washer. Pressure reducer—————————The pressure reducer that is integrated into the different units allows the measuring device to be connected directly to the filling panel as well as directly to a breathing-air / scuba cylinder. Permanently installed units are equipped with a magnet valve that prevents a pressure drop in the compressor system after the measuring process is finished. safeguarding air-quality √ HIGH QUALITY SENSORS √ FROM SCIENTIFIC APPLICATIONS √ DURABLE, PRECISE MEASUREMENTS √ DATA LOGGING, USB, NETWORK, PRINTER Monitoring of air-quality in breathingair filling systems. This fully electronic monitoring system is integrated into the high-pressure compressor, it ensures purity of breathing-air, it includes saturation monitoring for drying agents in breathing-air high-pressure compressors, it is protected as a utility model. AIRSAVE ULTIMATE is the first device, which monitors CO, CO2, O2, SO2, NO, NO2,H2O, dew point, residual oil, temperature, and absolute humidity in mg³, and co

BREATHE - WE TAKE CARE OF YOUR AIR AIRSAVE ULTIMATE and DIN EN 12021: 2014 For many years little attention was paid to the monitoring of breathing-air. DIN 3188 and the later European Standard DIN EN 12021 were considered as more or less discretionary provisions. Still many operators do not realize their responsibility and the consequences of their attitude. CO, CO2, O2, SO2, NO, NO2 pressure dew point (tdp), humidity / absolute water in mg³, pressure (P), temperature (T), aerosols, residual oil with concentrations down to 0.001 mg per m3, upgradeable for monitoring other gases* Most operators...