Product Data HEMPATEX ENAMEL 56360 Description: HEMPATEX ENAMEL 56360 is a finishing coat based on acrylic resin and nonchlorinated plasticizer for optimum gloss and colour retention. Physically drying. Resistant to salt water, splashes of aliphatic hydrocarbons and animal and vegetable oils. As an interior and exterior finishing coat in HEMPATEX systems in moderately to severely corrosive environment. Service temperature: Maximum, dry exposure only: 80°C/176°F see REMARKS overleaf Part of Group Assortment. Local availability subject to confirmation. PHYSICAL CONSTANTS: Shade nos/Colours: Finish: Volume solids, %: Theoretical spreading rate: Flash point: Specific gravity: Surface dry: Dry to touch: VOC content: *Wide range of colours available via Hempel's MULTI-TINT system. The physical constants stated are nominal data according to the HEMPEL Group's approved formulas. APPLICATION DETAILS: Application method: Thinner (max.vol.): Nozzle orifice: Nozzle pressure: Cleaning of tools: Indicated film thickness, dry: Indicated film thickness, wet: Overcoat interval, min: Overcoat interval, max: Safety: Airless spray / Air spray / Brush 08080 (5%) / 08080 (15%) / 08080 (5%) 0.017 " 150 bar [2175 psi] (Airless spray data are indicative and subject to adjustment) HEMPEL'S THINNER 08080 35 micron [1.4 mils] 100 micron [4 mils] According to specification. According to specification. Handle with care. Before and during use, observe all safety labels on packaging and paint containers, consult HEMPEL Safety Data Sheets and follow all local or national safety regulations. Date of issue: December 2013 - Product Data Sheet

HEMPATEX ENAMEL 56360 SURFACE PREPARATION: New steel: According to specification. Repair and maintenance: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Remove all rust and loose material by abrasive blasting or power tool cleaning. Dust off residues. Touch up bare spots to full film thickness. APPLICATION CONDITIONS: Apply only on a dry and clean surface with a temperature above the dew point to avoid condensation. In confined spaces provide adequate ventilation during application and drying. PRECEDING...