Product Data HEMPALIN ENAMEL 52140 Description: HEMPALIN ENAMEL 52140 is a glossy alkyd enamel which forms a weather resistant coating. It is flexible and resistant to salt water and spillage of mineral oil and other aliphatic hydrocarbons. As a general purpose finishing coat in alkyd systems on exterior and interior steel and woodwork in mildly to moderately corrosive environment. As a finishing coat in engine rooms including tank tops, main engines and auxiliary machinery. Service temperature: Maximum, dry exposure only: 120°C/248°F (These temperatures may cause yellowing/discolouration.) Approved as a low flame spread material when used as part of a predefined paint system. Please refer to “Declaration of Conformity” on www.Hempel.com for further details. Complies with EU Directive 2004/42/EC: subcategory i. Part of Group Assortment. Local availability subject to confirmation. PHYSICAL CONSTANTS: Shade nos/Colours: Finish: Volume solids, %: Theoretical spreading rate: Flash point: Specific gravity: Surface-dry: Through-dry: VOC content: Shelf life: 10000* / White High-gloss 46 ± 1 15.3 m2/l [613.5 sq.ft./US gallon] - 30 micron/1.2 mils 38 °C [100.4 °F] 1.1 kg/litre [9 lbs/US gallon] 3 hour(s) 20°C/68°F 5.5 hour(s) 20°C/68°F 429 g/l [3.6 lbs/US gallon] 5 years (25°C/77°F) from time of production. *Wide range of colours available via Hempel's MULTI-TINT system. The physical constants stated are nominal data according to the HEMPEL Group's approved formulas. APPLICATION DETAILS: Application method: Thinner (max.vol.): Nozzle orifice: Nozzle pressure: Cleaning of tools: Indicated film thickness, dry: Indicated film thickness, wet: Overcoat interval, min: Overcoat interval, max: Airless spray / Air spray / Brush 08230 (5%) / 08230 (15%) / 08230 (5%) see REMARKS overleaf 0.018 " 150 bar [2175 psi] (Airless spray data are indicative and subject to adjustment) HEMPEL'S THINNER 08230 30 micron [1.2 mils] 75 micron [3 mils] see REMARKS overleaf see REMARKS overleaf Date of issue: January 2020 Handle with care. Before and during use, observe all safety labels on packaging and paint containers, consult HEMPEL Safety Data Sheets and follow all local or national safety regulations

Product Data HEMPALIN ENAMEL 52140 SURFACE PREPARATION: New steel: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Power tool cleaning to St 3 or abrasive blasting to Sa 2 (ISO 8501-1:2007). Prime with: HEMPALIN Repair and maintenance: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Remove all rust and loose material by abrasive blasting or power tool cleaning. Dust off residues. Prime with: HEMPALIN. Touch up bare...