Product Data HEMPADUR PRO ZINC 17380 17380 : BASE 17389 : CURING AGENT 98382 Description: HEMPADUR PRO ZINC 17380 is a two-component, zinc rich epoxy primer. Offers cathodic protection of local mechanical damage. Recommended use: As a high solids, versatile, long-term primer on steel for epoxy coating systems in medium to severely corrosive environments. Service temperature: Maximum, dry exposure only: 160°C/320°F Certificates/Approvals: Conforms to NORSOK M-501, rev. 5, system no. 1. Availability: Part of Group Assortment. Local availability subject to confirmation. PHYSICAL CONSTANTS: Shade nos/Colours: Finish: Volume solids, %: Theoretical spreading rate: Flash point: Specific gravity: Surface dry: Dry to touch: Fully cured: VOC content: 10830 / Grey. Flat 60 ± 1 12 m2/l [481.2 sq.ft./US gallon] - 50 micron/2 mils 19 °C [66.2 °F] 2.8 kg/litre [23.5 lbs/US gallon] 0.5 approx. hour(s) 20°C/68°F 1 hour(s) 20°C/68°F 7 day(s) 20°C/68°F 353 g/l [2.9 lbs/US gallon] - The physical constants stated are nominal data according to the HEMPEL Group's approved formulas. APPLICATION DETAILS: Version; mixed product: Mixing ratio: Application method: Thinner (max.vol.): Pot life: Nozzle orifice: Nozzle pressure: Cleaning of tools: Indicated film thickness, dry: Indicated film thickness, wet: Recoat interval, min: Recoat interval, max: Safety: Date of issue: January 2012 - 17380 BASE 17389 : CURING AGENT 98382 4 : 1 By volume Airless spray / Air spray / Brush 08450 (5%) / 08450 (15%) / 08450 (5%) see REMARKS overleaf. 2 hour(s) 20°C/68°F 0.017 - 0.021 " 150 bar [2175 psi] (Airless spray data are indicative and subject to adjustment) HEMPEL'S TOOL CLEANER 99610 50 micron [2 mils] see REMARKS overleaf. 75 micron [3 mils] According to specification. According to specification. Handle with care. Before and during use, observe all safety labels on packaging and paint containers, consult HEMPEL Safety Data Sheets and follow all local or national safety regulations. Page: 1/2 Product Data Sheet

HEMPADUR PRO ZINC 17380 SURFACE PREPARATION: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Abrasive blasting to Sa 2½ (ISO 8501-1:1988) with a sharp-edged surface profile corresponding to Rugotest No. 3, BN9a, Keane-Tator Comparator, 2.0 G/S, 2 S, or ISO Comparator, Medium (G). APPLICATION CONDITIONS: Use only where application and curing can proceed at temperatures above: - 10°C/14°F. The temperature of the surface must also be above these limits. The temperature of paint itself should be 15°C/59°F or...