Product Data HEMPADUR MULTI-STRENGTH 45753 Low to medium temperatures 45753: BASE 45755 : CURING AGENT 98750 Description: HEMPADUR MULTI-STRENGTH 45753 is a self-priming, two-component, highbuild, pure epoxy paint which cures to an abrasion and corrosion resistant coating. Applicable by standard heavy duty airless spray equipment. As a heavy duty coating for areas exposed to abrasion and aggressive corrosive climate such as ramps, ship hulls and holds of bulk carriers. As a ballast tank coating for special purposes such as chemical carriers carrying hot cargoes and other purposes where “pure epoxy coating” is requested. As a finishing coat where a cosmetic appearance is of less importance. HEMPADUR MULTI-STRENGTH 45753 is intended for use in cold climates - see APPLICATION CONDITIONS overleaf. Service temperature: Maximum, dry exposure only: 140°C/284°F In water (no temperature gradient): 50°C/122°F Other liquids: Contact HEMPEL Approved by Lloyd's Register of Shipping as a corrosion control coating. HEMPADUR MULTI-STRENGTH 45753 tested by Teknologisk Institut AS, Norway, and approved for internal use in pipe lines for water power generation according to NS 5417. Recognized Abrasion Resistant Ice Coating by Lloyds Register. Complies with EU Directive 2004/42/EC: subcategory j. Part of Group Assortment. Local availability subject to confirmation. PHYSICAL CONSTANTS: Shade nos/Colours: Finish: Volume solids, %: Theoretical spreading rate: Flash point: Specific gravity: Dry to touch: Fully cured: VOC content: The physical constants stated are nominal data according to the HEMPEL Group's approved formulas. APPLICATION DETAILS: Version, mixed product: Mixing ratio: Application method: Thinner (max.vol.): Pot life: Nozzle orifice: Nozzle pressure: Cleaning of tools: Indicated film thickness, dry: Indicated film thickness, wet: Overcoat interval, min: Overcoat interval, max: 45753 BASE 45755 : CURING AGENT 98750 3 : 1 by volume Airless spray 08450 (5%) (Consult the separate APPLICATION INSTRUCTIONS) 1 hour(s) 20°C/68°F 0.021 - 0.023 " 250 bar [3625 psi] (Airless spray data are indicative and subject to adjustment) HEMPEL'S TOOL CLEANER 99610 200 micron [8 mils] see REMARKS overleaf 250 micron [10 mils] see REMARKS overleaf see REMARKS overleaf Handle with care. Before and during use, observe all safety labels on packaging and paint containers, consult HEMPEL Safety Data Sheets and follow all local or national safety regulations.

Product Data HEMPADUR MULTI-STRENGTH 45753 SURFACE PREPARATION: New steel: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Abrasive blasting to minimum Sa 2½ (ISO 8501-1: 2007) with a surface profile corresponding to Rugotest No. 3, N9a to N10, preferably BN9a to BN10, Keane-Tator Comparator, 2.0 G/S or ISO Comparator, Medium (G). Repair and maintenance: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Remove all rust...