RZR 1000
8Pages

HEATER @ CRAFT Heater Installation Instructions: POLARIS 1000 RZR 6672 W. Boekel Rd. Rathdrum. ID. 83858 I (288) 687-4488 I www.heatercraft.com

NOTES: KIT NO. 2879001 POLARIS 1000 RZR This heater unit installs inside the cab, on the center console- just forward of the cup holders on the floor/shifter console. The Dry-Box center dash compartment will be permanently removed. Never work on a hot vehicle, severe burns can occur. When bleeding the cooling system-check engine coolant level and burp tank often until all of the air is removed from the system. 1. Lift the front of the RZR 1000 vehicle and secure with jack-stands. Remove the driver’s and passenger side tire/wheel. Drain the coolant system by removing the lower radiator hose...

7. Attach the provided 2.00” vent hose to the open hose flange on the front of the heater and secure with a wire tie. 9. Align the heater bracket on the console and drill & install the two provided Push-Rivets in the heater mounting bracket- just forward of the cup holder that were left out in Step-6. .316” Drill Bit (Photo 7) 8. Remove the top dash panel’s Push-Rivets to access the area where the defroster vent will be located. This piece does not need to be removed- just loose. Using the Dash Cutout Template and a 2.00” hole saw; cut the hole for the vent- ALWAYS CHECK BEHIND OR...

14. Top off the radiator and burp tank with a 50/50 antifreeze mix, to appropriate levels. Start RZR and toggle through the system on the dash gauge to the ‘coolant temperature’ stage and monitor until it reads 180F then shut the vehicle off. Leave the heater in the OFF position for this step. Allow the vehicle to cool down and repeat the process until all of the air has been evacuated from the system- which can take up to 30-40 min. 14.1 The ‘bleeding’ process can be expedited by driving the vehicle prior to the cool down intervals and loosening the passenger Tee fitting’s ¾” hose clamp to...