Full General Datasheet SPABOND 5 MINUTE TACKING AND SECONDARY BONDING ADHESIVE ¬ Ideal when used as an “extra hand” in assembly Can be used alongside other Spabond products INTRODUCTION Spabond 5-Minute uses Gurit’s fast-setting technology. It combines outstanding bonding speed with a simple 1:1 by weight and by volume mix ratio. This thixotropic system is ideal for general bonding and repair work on a wide range of materials. Components bonded with Spabond 5 Minute demonstrate high bond strengths and can be handled after a very short period of time. Spabond 5-Minute can be used in conjunction with other Spabond products as a “spot weld” system in situations where the use of conventional clamps is not possible.

AVAILABILITY The product is available in a number of formats please contact your local customer support or download the latest product catalogue available on www.gurit.com. TRANSPORT & STORAGE The resin and hardeners should be kept in securely closed containers during transport and storage. Any accidental spillage should be soaked up with sand, sawdust, cotton waste or any other absorbent material. The area should then be washed clean (see appropriate Safety Data Sheet). Adequate long term storage conditions will result in a shelf life of 1 year for both the resin and hardeners. Storage should...

This 1 page product summary is intended for use in conjunction with further advice provided under the Instructions for Use section. All data has been generated from typical production material and does not constitute a product specification. MIXING AND HANDLING *Clamp time data shows the time taken to achieve a 2000N bond strength. **initial cure of 24 hours at 21°C CARTRIDGE USE If dispensing product from twin cartridges with a mixing / dispensing head, please discard the first mix head length of resin and hardener components, prior to applying adhesive to the job, in order to ensure thorough...

NOTICE All advice, instruction or recommendation is given in good faith but the selling Gurit entity (the Company) only warrants that advice in writing is given with reasonable skill and care. No further duty or responsibility is accepted by the Company. All advice is given subject to the terms and conditions of sale (the Conditions) which are available on request from the Company or may be viewed at Gurit's Website: www.gurit.com/terms-and-conditions.aspx The Company strongly recommends that Customers make test panels in the final process conditions and conduct appropriate testing of any goods...