Full Datasheet Smartcure™ 5 MINUTE CURING PREPREG ¬ Epoxy Prepreg Optimised for Press Moulding Applications Developed for Automotive Component Production Good Surface Finish Hot-in, Hot-out Press Processing 5 Minute Cure Time at 150°C INTRODUCTION Smartcure™ Prepreg has been specifically developed for high volume press moulding applications and enables users to perform cycle times of 5 minutes. The products characteristics facilitate simple preforming prior to moulding and the ability to fill edged detail during moulding, allowing net shaped parts to be manufactured.

Smartcure™ is available in a range of product formats, including AFP tape formats. Please consult your local sales contact for further information. Full contact details can be found at www.gurit.com.

All data presented in this datasheet is based on the mechanical testing of a single batch of material. Data presented is based on average values. CURED LAMINATE PROPERTIES Cured using standard processing techniques and a minimum cure time of 5 minutes at 150°C (302°F). * normalised to 60% fibre volume fraction ** normalised to 60% fibre volume fraction for RC380T only

NOTICE All advice, instruction or recommendation is given in good faith but the selling Gurit entity (the Company) only warrants that advice in writing is given with reasonable skill and care. No further duty or responsibility is accepted by the Company. All advice is given subject to the terms and conditions of sale (the Conditions) which are available on request from the Company or may be viewed at Gurit's Website: www.gurit.com/terms-and-conditions.aspx The Company strongly recommends that Customers make test panels in the final process conditions and conduct appropriate testing of any goods...