DATA SHEET NEOPRENE GEL ADHESIVE PREPARATION OF SURFACE The surfaces to be joined must be clean, dry and grease-free. APPLICATION Do not mix the adhesive before use, and apply it with a brush or toothed spatula. Spread an even coat (150 g) onto the two surfaces to be joined. Leave the solvents to evaporate for 10 to 20 minutes, depending on the temperature and the surfaces. Bring the parts together with care, because adhesion is immediate and irreversible. Press strongly together. Setting is not complete until after 48 to 72 hours. In cold and wet weather, ensure that the materials and the adhesive are at the right temperature (over 10°C) in order to avoid the formation of dew when the solvents are evaporating, since this will reduce the effectiveness of the join. PRECAUTIONS FOR USE Easily flammable. Before all uses, consult the specification safety. To bring back to a temperature of 18, 20°C before homogenisation and use. HEALTH AND SAFETY See data sheet This information corresponds to the actual state of our knowledge and has the sole object of informing you about our products and possible applications. It is objectively given but does not imply any guarantee by us. Our company may modify all these details at any time SOROMAP PEINTURE VERNIS ZA de Beligon – 1 Rue Maurice Mallet 17300 ROCHEFORT S/MER Tél : 05 46 88 36 13 • Fax : 05 46 88 36 25 • Email : william.thomas@soroma