DATA SHEET LIQUID NEOPRENE ADHESIVE PREPARATION OF SURFACE The supports must be dry, dustfree, nor polluting grease or other agents which could harm joining. If the supports must be cleaned, to use for example the MEK. The solvents must be in conformity with the local regulations. To check the compatibility of solvent used with the substrates. To sandpaper metal surfaces if necessary. NB: At the time of the use of solvents, to extinguish all sources of ignition and to follow the handling and safety specifications given by the manufacturer for this type of product APPLICATION To apply a uniform layer to two surfaces to be assembled with a brush or spatula. To let evaporate the solvents (10 minutes according to the temperature, the grammage, the hygrometry and supports). To take care not to exceed limiting open time. To post with precision the two parts, because the catch is immediate and irreversible. To strongly press during 2 to 3 seconds. The catch is maximum only after 48 to 72 hours. In wet and cold weather, to make sure that the materials and the adhesive are at correct temperatures (higher than 10°C), in order to avoid a formation of dew at the time of the evaporation of the solvents which would harm the quality of joining. Cleaning: To clean the tools with MEK PRECAUTIONS FOR USE Easily flammable and irritant. Before all uses, consult the specification safety. To bring back to a temperature of 18, 20°C before homogenisation and use HEALTH AND SAFETY See data sheet This information corresponds to the actual state of our knowledge and has the sole object of informing you about our products and possible applications. It is objectively given but does not imply any guarantee by us. Our company may modify all these details at any time SOROMAP PEINTURE VERNIS ZA de Beligon – 1 Rue Maurice Mallet 17300 ROCHEFORT S/MER Tél : 05 46 88 36 13 • Fax : 05 46 88 36 25 • Email : william.thomas@sor