INFLATABLES ANTIFOULING

Product catalog summary

Product Overview: The document details an antifouling paint designed for inflatable rubber dinghies, suitable for neoprene, rubber fabric, PVC, and Hypalon surfaces. It is noted for its elasticity, flexibility, and adhesion.

Physical Characteristics: The antifouling cures through thinner evaporation, has a specific weight of 1.20 kg/l, a dry volume of 22%, and a flash point between 23°C and 55°C. It is available in matte black and grey.

Surface Preparation: Surfaces must be thoroughly cleaned and free of rubber dust. The antifouling should be diluted by 10-15% with thinner and applied only on dry surfaces.

Application Instructions: Mix the antifouling thoroughly before application. Apply two coats with an 8-hour interval, inflating the craft to 80%. Wait 24-48 hours after the second coat before fully inflating and launching the craft, which should not occur until at least 24 hours after the last coat.

Usage Characteristics: The drying time before use is a minimum of 24 hours at 20°C. The application temperature should be between +5 and +35°C. Each coat should have a wet film thickness of 70 µ and a dry film thickness of 15 µ, with a practical coverage of 12 m²/l.

Packing and Storage: The product is packaged in 750 cc containers and should be stored in a closed container away from heat, cold, and damp.

Precautions: Users should wear gloves, goggles, and protective clothing and avoid smoking during use.

Health and Safety: Refer to the data sheet for detailed health and safety information.

This document provides information based on current knowledge and is intended to inform about the product and its applications. The company reserves the right to modify details at any time.

Catalog excerpts

PREPARATION OF SURFACE To ensure a perfect paint adhesion, clean the surface thoroughly. Remove all traces of rubber dust with a cloth impregnated with a solvent. It is imperative to dilute the antifouling from 10 to 15 % with the thinner. Only paint onto a dry surface. APPLICATION Mix the antifouling for several minutes in order to ensure it is completely uniform. Apply 2 coats with interval of 8 hours, the craft should be inflated to 80% Wait 24 to 48 hours after the second coat before re-inflating the craft. The boat should not be launched until at least 24 hours after the application of the last coat (maximum 2 months). Only apply with a brush surface. PRECAUTIONS FOR USE Wear gloves, goggles and protective clothes. Do not smoke when using. HEALTH AND SAFETY See data sheet This information corresponds to the actual state of our knowledge and has the sole object of informing you about our products and possible applications. It is objectively given but does not imply any guarantee by us. Our company may modify all these details at any time SOROMAP PEINTURE VERNIS ZA de Beligon – 1 Rue Maurice Mallet 17300 ROCHEFORT S/MER Tél : 05 46 88 36 13 • Fax : 05 46 88 36 25 • Email : william.thomas@soromap.

Open the catalog to page 1

INFLATABLES ANTIFOULING

INFLATABLES ANTIFOULING

Catalog excerpts

All GROUPE SOROMAP catalogs and brochures