MSP CLEAR
1 / 2Pages

TECHNICAL DATA SHEET FIXCLEAR - MSP CLEAR Revision: 01/2011 Technical Data: Base Consistency Curing system Skin Formation(*) Cure Rate (*) Hardness Change In Volume Specific Gravity Maximum Deformation Temperature Resistance (cured) Elastic Modulus 100% Tear Strength Elongation At Break Shear Strength: Page 1 of 2 Polymer Stable Paste 100% Clear Moisture Cure Approx. 12 minutes (23°C and 75% R.H) 3mm/24Hrs (23°C and 75% R.H) 40 Shore A < 2% 1.04g/mL ± 15% -40°C to 100°C 1.0 N/mm2 1.0N/mm2 > 330% 1.0n/mm2 (*) Values may vary depending on environmental conditions Product: Fixseal MSP Clear is a high quality single component 100% clear joint sealant with high adhesive strength. It is based on MS-Polymer®, is chemically neutral and fully elastic. For use in low movement joints in construction, automotive, marine and aerospace industries where a mould resistant, tough and flexible bond is required. Characteristics: - High bond strength on most all surfaces - Excellent adhesion on porous and nonporous substrates - High performance mechanical properties - Flexible elastic rubber; movement accomadation up to 20% - Easy application - No bubble formulation within the sealant. - Primerless adhesion (except where capillary water pressure can occur) - Easy to tool and finish - Good UV resistance. - Ecological advantages: free of isocyanates, solvents, halogens and acids - Minimal health and safety considerations Characteristics continued: - Can be painted (compatibility tests recommended) - Resistance to many chemicals - No staining of porous materials such as natural stone, granite, marble and fibreglass. Applications: Sealing and bonding in the marine, construction and transport industries. Sealing of floor and wall joints and low movement joints that are exposed to ongoing traffic. Bonding and sealing in joints subject to vibration. Connection joints in sheet metal fabrication. Flexible bonding in boats, car bodies, caravans and containers. Packaging: Colour – 100% Clear, may discolour in extreme conditions Packaging – 290mL cartridge Shelf life: 18 months Cartridges; In unopened packaging in a cool and dry storage place a t temperatures between +5°C and +25°. Note: The contents contained in this documentation are the result of our experiments and our experienceand have been submitted in good faith. Because of the diversity of the materials and substrates and the real number of possible applications which are out of our control we cannot accept any responsibility for the results obtained. In every case it is recommended to carry out preliminary experiments and compatibility tests. Fixtech Pty Ltd. PO Box 568, Southport, Qld 4215. Tel: +61 (0)7 5530 1099. Fax: +61 (0)7 5530 1322 Email: info@fixtech.com.au Web: www.fixtech.com.au

TECHNICAL DATA SHEET FIXCLEAR - MSP CLEAR Revision: 01/2011 Surfaces: State of Surface: Abraded, clean, dry, free of dust and grease Priming: For porous substrates Primer PR10 may be applied. Polypropylene, Primer PR20. Nonporous substrates may be cleaned with Methylated Spirits , alcohol cleaner or wax and grease remover. We recommend a preliminary compatibility test. Joint Dimensions: Minimal Width: 2mm (bonding) 5mm (joint) Maximum Width: 10mm (bonding) 30mm (joint) Minimum Depth: 5mm(joint) Recommendation: width of joint = 2 x depth Resistance to Chemicals: Good resistance to water,...