MSP 15
2Pages

TECHNICAL DATA SHEET FIX15 - MSP15 Revision: 01/2011 Technical Data: Base Consistency Curing system Skin Formation(*) Cure Rate (*) Hardness Change In Volume Specific Gravity Maximum Deformation Temperature Resistance (cured) Elastic Modulus 100% Tensile Strength Elongation At Break Shear Strength: Substrate Thickness Shear Velocity Page 1 of 2 Polymer Stable Paste Moisture Cure Ca. 12 min (23°C/ 75% R.H) 3mm/24hr (20°C/65%R.H) 48 Shore A <2% 1.64 g/mL ± 20% -40°C→100°C 1.0 N/mm² (DIN 53504) 2.0 N/mm² (DIN 53504) >400% (DIN53504) >1.0N/mm² AlMgSi1 2mm 10mm/min Testing, University of Queensland 2005 (*) Values may vary depending on environmental conditions Product: Fixseal MSP15 is a high quality single component joint sealant with high strength. It is based on MS Polymer®, which is chemically neutral and fully elastic. For use in low movement joints in the construction, automotive, marine and aerospace industries where a strong mould and UV resistant flexible rubber is required. Characteristics: • High bond strength on a wide variety of substrates. • Excellent adhesion on porous and non-porous surfaces • High performance mechanical properties • Flexible elastic rubber; movement accommodation up to 20% • Assed under criteria of NOHSC Australia and considered as non-toxic, Certificate No.2146. • No bubble formation within the sealant Characteristics continued: • Primerless adhesion (except where capillary water pressure can occur) • Easy to tool and finish • Excellent extrudability and UV resistance • Ecological advantages- free from isocyanates, solvents, halogens and acids • Minimal health and safety considerations • Can be painted with all water based paints and many other systems • Chemically resistant • No staining of porous materials such as natural stone, granite, marble, etc. Applications: Sealing and bonding of areas with high traffic, floor joints and low movement wall joints. Suitable for, but not limited to steel, aluminium, stainless, PVC fiberglass, concrete, glass, timber. Connection joints in sheet metal fabrication. Sealing and bonding of coachwork, caravans, Note: The contents contained in this documentation are the result of our experiments and our experienceand have been submitted in good faith. Because of the diversity of the materials and substrates and the real number of possible applications which are out of our control we cannot accept any responsibility for the results obtained. In every case it is recommended to carry out preliminary experiments and compatibility tests. Fixtech Pty Ltd. PO Box 568, Southport, Qld 4215. Tel: +61 (0)7 5530 1099. Fax: +61 (0)7 5530 1322 Email: info@fixtech.com.au Web: www.fixtech.com.au

TECHNICAL DATA SHEET FIX15 - MSP15 Revision: 01/2011 Page 2 of 2 Applications continued: buses, boats, aircraft, domestic and commercial construction. Packaging: Colour - Black and White Packaging – 290mL cartridge, 600mL foil bag Shelf life: 15 months Cartridges; 12 months Foil Bags In unopened packaging in a cool and dry storage place a t temperatures between +5°C and +25°. Surfaces: State of Surface: Abraded, clean, dry, free of dust and grease Priming: For porous substrates Primer PR10 may be applied. Polypropylene, Primer PR20. Nonporous substrates may be cleaned with Methylated...