FS 200
1 / 2Pages

TECHNICAL DATA SHEET FIXSIL FS200 Revision: 01/2011 Technical Data: Base Consistency Curing system Skin Formation(*) Tack Free Time Protetion From Sunlight Whilst Curing Hardness Change In Volume Ozone Resistance UV Resistance Temperature Resistance (cured) Joint Movement Capability Tensile Strength Modulus Tear Strength Page 1 of 2 Alkoxy Hybrid Stable Paste Moisture Cure 39 minutes (23°C / 50% R.H) 3 Hours Minimum 7 Days (23°C / 50% R.H) 25 Shore A None Excellent Excellent -48°C to 93°C ±50% 2.45 MPa 0.24 MPa; at 50% Elongation 3.5kN/m (*) Values may vary depending on environmental conditions Product: FixSil FS200 is a high quality structural, neutral cure, elastic low modulus silicone sealant. Non paintable Characteristics: - Easy Application - Permanent colour, UV resistant - Permantently elastic - Good adhesion on many materials - Almost no smell - Slow skinning time; ideally suited to long joint runs - Unaffected by sunlight, ultraviolet light, radiation, rain, snow and temperature extremes. - Primerless Adhesion in most applications - ±50% extension and compression of joint width Applications: Acrylic, Perspex and other polymer based window systems and glass adhesion and sealing applications. Suitable for marine exposure Packaging: Colour - Black Packaging – 310mL cartridge Shelf life: 12 months Cartridges In unopened packaging in a cool and dry storage place a t temperatures between +5°C and +25°. Note: The contents contained in this documentation are the result of our experiments and our experienceand have been submitted in good faith. Because of the diversity of the materials and substrates and the real number of possible applications which are out of our control we cannot accept any responsibility for the results obtained. In every case it is recommended to carry out preliminary experiments and compatibility tests. Fixtech Pty Ltd. PO Box 568, Southport, Qld 4215. Tel: +61 (0)7 5530 1099. Fax: +61 (0)7 5530 1322 Email: info@fixtech.com.au Web: www.fixtech.com.au

TECHNICAL DATA SHEET FIXSIL FS200 Revision: 01/2011 Page: 2 of 2 Surfaces: State of Surface: Abraded, clean, dry, free of dust and grease. Light sand of acrylic panels Priming: For porous substrates Primer PR10 may be applied. Polypropylene; Primer PR20. Nonporous substrates amy be cleaned with Methylated Spirits , alcohol cleaner or wax and grease remover. Application: Method: Manual or pneumatic caulking gun Application temperature: +1°C to +40°C Tooling: Mild diluted soapy solution before skin formation Health- and Safety Recommendation: Apply the usual industrial hygiene. Wear gloves...