WIRE FURLERS 4 24 to 30 feet units STG FROM 24 TO 30 FEET Top stainless steel toggle Fixes the top swivel on the mast (included) Head swivel Joins the wire and the mast, this swivel allows the wire to turn and supports the loads For smaller sailboats, the STG is a wire structural furler, light and easy to install. Just add a metal wire with terminals to the STG furling kit including a continuous line drum, deck+mast toggles, head swivel connected to the mast, and a halyard swivel connected to the sail head/halyard. The STG advantages: - up to 5 times lighter than a conventional furling system; - waterproof bearing and maintenance free; - Maximum luff thanks to the continuous line drum; - Simple installation, sail fitted on snap shackles; - Strong (3 and 4 tons loads). Thrust bearing with Torlon® ball bearings. Twin rim joints proofing against salted water and sun light photo credit : Kyansailing - CB66 Racer Continuous line drum (see previous page) Boat length from 7,5 to 9,5 meters from 23 to 31’ from 8 to 10 meters from 25 to 32’ according to boat type Breaking load Halyard swivel Stainless steel wire ø 5 to ø 7 mm (not included). Sail fitted with hanks or zip luff. Link plates Allows adjusting the length of the forestay that is easily removed. Ideal for unstepping operations) Bottom stainless steel toggle * in comparison, it is 1mm smaller than a Cd-Rom 5 mm to ø 7 mm STAINLESS STEEL WIRE The stainless steel wire is not delivered with the kit. We recommend reliable, strong and high quality products of Sparcraft Rigging, joint company of the Losange Group. Stainless steel wire (type 1x19) used on 3-4 T Facnor wire furler