Auto Track Falcon ! Features: • Solid state electronics replace relay logic circuits. • Traverse motor and gearbox are integrated into one unit. • Wire reinforced drive belt for continuous cycles. • Power wand versus reel cord for maintenance free power to the cutting head. • Simplified controls for operator interface. • Remote control activator (optional foot switch/25' or 50' cord. The Auto Track Falcon control panel includes controls for: • Power on/off • Traverse track speed control • Manual or auto-lift mode • Ply counter • Blade sharpening • "Start cut" button Standard Features: • Auto Lift • Ply Counter • Speed Setting • Compression Foot • Remote Control Optional Features: • Cloth Alignment Bar • Manual Foot Pedal Control Eastman*Over a Century of Cutting Expertise While similar in basic function to Eastman's Falcon IV end cutter, the Auto Track Falcon II offers the time saving advantages of automatic operation. The travel of the Auto Track's cutting head across the track and the elevating and lowering of the track lifting mechanism are motorized. The remote control enables the operation to activate the Auto Track Falcon's cutting cycle as soon as the operator is finished pulling the ply down the table, therefore gaining valuable seconds per ply. Specifications Horsepower: .15 hp Cutting Capacity: 1/2" up to 1-1/4" (3.20 cm with compressible Table widths available: material Eastman Machine Company 779 Washington Street, Buffalo, NY 14203 | p:+1-716-856-2200 | f:+1-716-856-1140 www.eastmancuts.com | [email protected] | Factory test cutting available

Eastman Machine Company 779 Washington Street, Buffalo, NY 14203 | p: +1-716-856-2200 | f: +1-716-856-1140 www.eastmancuts.com | [email protected] | Factory test cutting available Free of Charge