Pressure Fuel Tank Gauge Module The E-Plex 318PFTG series can be used in a wide variety of applications. It is enclosed in a sealed container for use in diesel fuel, fresh water, grey water, and black water tanks. The fuel tank gauge can measure fluid up to a maximum depth of 14.9 feet in diesel and 11.5 feet in water, and measures pressure of fluid in a tank in one percent increments. Elevation has no effect on the output reading and tank shape has no effect on the accuracy of the pressure fuel tank gauge, which makes it useful in applications where the tank shape is irregular. The fuel tank gauge can be used in multiple configurations, depending on the construction of the tank whether it is plastic or metallic. The E-Logic software allows for accurate calibration by building a tank curve table during the initial fill process. A default table can be established if the tank parameters are already known. • 6 channels with outputs capable to 15 amps each (50 amps total) • 2 channels with PWM dimming capabilities • Reverse battery protected • Status LED's for each channel • Thermal, short circuit, and programmable overload protection • Local electronic override capabilities • Designed for motor loads Powering systems - Empowering designers

Electrical Specifications Electrical Specifications Male 0.25" spade (quick-connect) terminals Direct Mount (chrome plated) Water resistant - MasterKleer general purpose PVC tubing Water resistant - Tygon fuel and lubricant tubing, translucent PVC type II top, 1 " NPT outer thread, 3/8" NPT inner thread PVC pipe II housing, 1.25" BSPP outer thread, 3/8" NPT inner thread PVC pipe II housing, 1.5" NPT outer thread, 3/8" NPT inner thread erating Temperatu Storage Temperature Operating Humidity Wiring Specifications The E-Plex data bus + (grey wire) operating range is 10 to 32 VDC, 25 to 30 mA. E-Plex...

Mounting Specifications Direct Mount - The housing assembly screws directly into a 0.5" NPT opening on the side or bottom of the tank. If mounted to the side it should be located near the bottom of the tank to be exposed to the maximum amount of fluid in the tank. For serviceability a valve is recommended in-line to allow for removal without emptying the tank. Rigid Series - The housing assembly drops into the tank from the top. An unobstructed path from the top to bottom of the tank would be required. The shape of the tank may also affect placement as ideally the face of the sensor should reach...

Part Number Builder flex tube for fuel 12.5 inch length, 1.5 inch male NPTtop housing, with a Delphi 2-pin sealed connector. Specify the type of body structure for your 318PTFG Specify the type of tube (skip this step if not selecting a FS in step 1) Specify the tube length in inches up to one decimal point (FS / RS models only) Specify the housing top (FS / RS models only Specify the connections style Powering systems - Empowering designers

318PFTG Series BATTERY 325QMM, 366HMM, 422QMM & 436MMX : 4, 6 or 10 channel multi-modules for control of lighting, including dimming and user-defined “mood” lighting POWER INVERTER 400ECM, 450ECM & 500CCM : Electronic control modules (“clocks”) that function as the master controller and programmer of the entire E-Plex system 361SIM : Inverter interface for complete control over your inverter functions 345LCD, 350LCD & 452LCD : 5.7”, 10” & 12” color LCD touchscreen displays that allow the user to interface with the E-Plex system, including monitoring and control functionality and includes direct...