Diesel Heater dickin/on - Made with Marine grade Stainless Steel - 12V Draft Assist Fan (Also 24v & 32v) - Glass Viewing Window 3” x 24“ Pipe w/ Barometric Damper 16-001 3” x 7“ Pipe w/ Barometric Damper 16-010 3” x 45 Degree Elbow 16-040 3” Deckfitting, Gasket & Dress Ring 16-050 3” DP Exhaust Cap 16-080 3” Flue Pipe Rain Lid 16-200 12“ x 24” Stainless Steel Wall Liner 25-000 Heat Output 12V Fuel Pump w/ Regulator 20-002 Fuel Filter Element 20-020 3” High Temp Shutoff 02-210 Low Volume Water Pump 20-005 The Newport Diesel Heater is a bulkhead mounted heater. A powerhouse for it’s size, it takes up very little space making it ideal for sailboats with little room to spare. It puts out a large amount of dry heat into the cabin keeping everyone warm and toasty and keeps everything dry inside the cabin. It has a nice viewing window that allows you to see the flame for a nice ambiance. For added heating heater can be equipped with a single turn water coil that can be used to move heat around the boat through our Radex heaters or used to heat a small hot water tank. The valve on the unit can be calibrated for use withDiesel, Kerosene or Stove Oil. The Newport Diesel requires a 3” diameter chimney that needs to be at least 4ft tall and should not exceed 8ft. A straight run is ideal but if bends are needed do not exceed 45 degrees. A fresh air vent close to the base of the heater is required to ensure a constant supply of oxygen to the heater. When installed on a sailboat it needs to be installed in a fore to aft configuration for operation whi