Diesel Heater dickin/on - Made with Marine Grade Stainless Steel - Beautiful black anodized Shroud - Glass viewing window - Cast Iron Lid for Cooking -12V draft assist fan (Also 24v & 32v) 4” x 24“ Pipe w/ Barometric Damper 17-001 4” x 7“ Pipe w/ Barometric Damper 17-010 4” x 45 Degree Elbow 17-040 4” Deckfitting, Gasket & Dress Ring 17-050 4” DP Exhaust Cap 17-080 4” Flue Pipe Rain Lid 17-200 12“ x 24” Stainless Steel Wall Liner 25-000 Heat Output 12V Fuel Pump w/ Regulator Fuel Filter Fuel Filter Element 4” High Temp Shutoff Low Volume Water Pump The Lofoton Diesel Heater is a floor mountedl heater with a cast iron lid. It has the same fuel consumption as our smaller diesel heaters but it boasts a larger amount of radiant heat output due to the increased surface area, larger bum chamber as well as the cast iron lid. It has a small viewing window that allows you to see the flame for a nice ambiance and the cast iron lid can be used as a cooking surface with enough room for a kettle or small cooking pot. For added heating heater can be equipped with a single or double turn water coil that can be used to move heat around the boat through our Radex heaters or used to heat a hot water tank. The valve on the unit can be calibrated for use with Diesel, Kerosene or Stove Oil. The Lofoton requires a 4” diameter chimney that needs to be at least 4ft tall and should not exceed 8ft. A straight run is ideal but if bends are needed do not exceed 45 degrees. A fresh air vent close to the base of the heater is required to ensure a constant supply of oxygen to the heater. When installed on a sailboat it needs to be installed in a fore to aft configuration for operation while