Diesel Heater dickin/on MARINE Fuel Consumption / 24hrs - Made with Marine grade Stainless Steel - Floor Mounted - 12V Draft Assist Fan (Also 24v & 32v) - Glass Viewing Window Installation Parts 3” x 24“ Stainless Pipe 16-000 3” x 24“ Pipe w/ Barometric Damper 16-001 3” x 7“ Pipe w/ Barometric Damper 16-010 3” x 45 Degree Elbow 16-040 3” Deckfitting, Gasket & Dress Ring 16-050 3” DP Exhaust Cap 16-080 3” Flue Pipe Rain Lid 16-200 12“ x 24” Stainless Steel Wall Liner 25-000 Heat Output 12V Fuel Pump w/ Regulator Fuel Filter Fuel Filter Element 3” High Temp Shutoff Low Volume Water Pump The Antartic Diesel Heater is a floor mounted heater. It is designed with a more traditional look for a bit of a throwback feel. It has the same fuel consumption as our smaller diesel heaters but it boasts a larger amount of radiant heat output due to the increased surface area and larger burn chamber. It has a nice viewing window that allows you to see the flame for a nice ambiance. For added heating heater can be equipped with a one or two turn water coil that can be used to move heat around the boat through our Radex heaters or used to heat a hot water tank.The valve on the unit can be calibrated for use with Diesel, Kerosene or Stove Oil. The Antartic requires a 3” diameter chimney that needs to be at least 4ft tall and should not exceed 8ft. A straight run is ideal but if bends are needed do not exceed 45 degrees. A fresh air vent close to the base of the heater is required to ensure a constant supply of oxygen to the heater. When installed on a sailboat it needs to be installed in a fore to aft configuration for operation while