Key features and benefits • Flexible sealing options • Opposing inlet and outlet connections with oversized ports • Shaft supported by two ball bearings in single sealed configuration • Self-priming with large suction capabilities • Low NPSH requirements • Self-draining, integral safety relief valve • No speed reduction required in six smaller sizes • Complete heating/cooling jacketing available Pumps in cast iron, for clean, non-abrasive liquids. The simple and compact construction makes it a low-cost pump, often used in modified versions by OEM customers. A close-coupled OEM model is also available. GP pumps are designed for use with IEC or NEMA flange motors. Available with 90° angular configuration. The DESMI ROTAN® pumps are used by all major oil product manufacturers around the world. With a strong focus on the customers' needs we aim to be the best application provider in the market. We aim to develop new innovations in pump technology. Therefore we cooperate closely with customers in order to solve individual application problems as well as develop new leading ideas for the industry. We are always looking for ways of doing things better. For more information on Industry solutions, please visit www.desmi.com MARINE & OFFSHORE DEFENCE & FUEL

Selection of Pump size PLEASE NOTE! ED: Capacity curve up to 151 GP: Capacity curve up to 101 To select the pump size with this table, you should only know: - The capacity - The viscosity We start at the top of the table with the viscosity, and draw a line down, staying within the colour of the selected viscosity range (see example). Then we start at the right of the table, drawing a horizontal line starting with the required capacity (see example). The point where these two lines meet determines the pump size, defined by the diagonal lines in the table. If you do not hit one of these pump lines...