FOOD WASTE DISPOSERS 500A-HK EXCELLENT SERIEs Included in standard delivery Contactor with motor protector Jam release wrench for grinding unit Disperator food waste disposers are used in galleys and kitchens around the world, providing an efficient and immediate removal of food waste whenever it arises. Thereby improving hygiene in the working environment, eliminating bad odors and bacteria formation and minimizing manual handling. feeding of waste into the disposer and is welded into an existing working bench or table top. The disposer inlet is partly covered by a labyrinth protection guard preventing accidental access to the grinding unit during operation. The guard is fitted with a safety interlock switch which stops the disposer when lifted. Our product range is designed with the user’s needs in focus and meets the modern requirements for handling food waste. The quality grinding unit with hardness from specially cast steel alloy, together with the unique sealing design between grinder and motor, ensure years of reliable operation and low maintenance cost. The disposer’s life span is extended further by the outer housing of stainless steel EN 1.4301 (AISI 304) and protection class IP55 for electrical components. Standard delivery includes a complete contactor with motor overload protector to be installed at site. The cone is delivered with flushing nozzles, a solenoid valve and a line strainer already assembled for easy installation. Cold water will automatically flow through the nozzles when the disposer starts and flush the food waste into the grinder chamber and continue into the sewer system or connected tank. The wide range of disposer sizes make it easy to adjust any installation to fit any workplace in a galley or kitchen. The HK discharge cone permits continuous Food waste disposers in the Disperator Excellent Series have the Declaration of Compliance issued by DNV verifying compliance with applicable sections of MARPOL consolidated edition 2011/2012 ANNEX V for disposal of ground food waste into the open sea

FOOD WASTE DISPOSERS 500A-HK EXCELLENT SERIEs Left side view Rear view Water flushing hose Air inlet in bottom plate for motor cooling, min 15mm clearance Disposer outlet to be connected to a water trap, see (1). Slope of drain pipe 2:100 to 5:100. Motor cable outlet and 2 m cable, see (2) Alternative positions of disposer outlet Cone and disposer housing, stainless steel EN 1.4301 (AISI304) Line strainer ½” BSP, Male to be connected to a flexible hose, see (1) for incoming water. Incoming water shall have a backflow preventer, see (1) Discharge cone welded to working top Solenoid valve, IP65...