PLASTIPRIM'O
1 / 1Pages

TECHNICAL DATA SHEET PLASTIPRIM’O GENERIC TYPE : UNIVERSAL PRIMER TYPE : SINGLE-PACK WATER-BASED ALKYD URETHANE DESCRIPTION: A new generation of environmentally-friendly marine paints, PLASTIPRIM’O is a singlepack water-based alkyd-urethane primer, applicable onto all types of paint supports (wood, steel, polyester, aluminium, etc.) in 1 to 2 coats, designed for the painting of all types of single-pack finishes and antifoulings. CLASSIFICATION: NFT 30.005 / Family I, Class 4a PHYSICAL PROPERTIES: Resin binder Density at 20°C Viscosity at 20°C Solids Flash point Colour Finish : Water-based alkyd-urethane : 1,26 : Thixotrope : 53% + 2% : Not applicable : Pearl grey : Matt-silk SURFACE PREPARATION: PLASTIPRIM’O must be applied to a clean and dry surface. Previous coats of paint should be lightly sanded to enable adhesion. Polyester: a light sanding of the polyester is recommended. On new polyester, remove wax mould marks with our DILUANT DECIRANT, then sand. Steel: steel brush or sandblast the surface to remove rust. Aluminium: chemical abrasion followed by freshwater rinsing is necessary to enable adhesion. Wood: thin to 10% for first coat. PAINT PREPARATION: Mix well before use. APPLICATION: PLASTIPRIM’O can be applied readily by spray, brush or roller. Thinning : Brush / roller : read-to-use Spray : 10 to 20% fresh water Recommended thickness / coat : 80 microns wet (40 microns dry). Drying time at 20 °C : Surface dry : 30 minutes To touch : 1 hour Recoat : 12 hours Coverage : 10 to 12 m²/l Cleaning solvent : Water Temperature range : Min. 5°C - max. 35°C PACKING AND SHELF-LIFE: Available in: Shelf-life: 0.750 litres, 3 litres and 15 litres excellent shelf-life when unopened and stored in a dry place. HEALTH AND SAFETY: Please refer to packaging. Material Safety Data Sheet available on request. V90727 This data sheet is aimed at informing our costumers about our products’ properties. These products are in accordance with the purpose they are intended for so far as they are applied in conformity with the rules outlined by SEPV & DTU in force when the work is being carried out. On account of the permanent evolution of techniques, it is up to our costumers to check with our company that the hereby data sheet has not been changed before starting work. SEPV - 2 Rue Henri ROL TANGUY— 91 180 ST GERMAIN LES ARPAJON - Tél. 01 69 88 13 10 - Fax. 01 60 84 04 81 - www.plasticoque.com