Installation Instructions for Tech Box and Cable Routing

1. Tech Box Placement

Attach the tech box securely to a flat area on the back of the board.

2. Cable Length Measurement

Using a rope, measure two lengths as illustrated:

• Length X: From the rear edge of the mast along the board to the battery box position.
• Length Y: From the motor up the mast to the bottom of the board.

Route the cable close to the board and mast to ensure it lies flush with the components after installation.

Tip: Position the motor approximately 20-25 cm from the board to provide support and ensure it protrudes from the water when fouled.

3. Ordering Cable Length

Add lengths X and Y to determine the total cable length required. When ordering, it is recommended to select a longer cable length to allow for excess cable to be wound up if not needed.

Notice

This sheet provides guidance on determining the appropriate cable length for installation.