PITTURA PER COPERTA TECHNICAL DATA SHEET Product description Modified alkyd finish for decks, boot toppings and bilges. This product is highly resistant to wear, abrasion and exposure to the marine environment. It can be submerged again and again in sea water without losing its gloss and colour. It is very flexible and adheres well to a wide range of primers. It is not suitable to be applied directly to galvanized panels and inorganic zinc primers. Product information Finish Colour Solids (by volume) Specific gravity Flash point VOC (calculated average content) Packaging Glossy Green .071, Red .171 ASTM D2369 UNI EN ISO 2811-1 UNI EN ISO 13736 ISO 11890-2/2006 Rev. February 2020 Boero Bartolomeo S.p.A. Via Macaggi 19 - 16121 Genova, Italia - Tel. +39 010 55001 - Fax +39 010 5500.291 www.boeroyachcoatings.com – [email protected]

PITTURA PER COPERTA TECHNICAL DATA SHEET Application and use SURFACE PREPARATION Fiberglass: Degrease the surface to be treated with an adequate solvent or detergent. Pressure wash with fresh water and remove any trace of oil and grease. All surfaces to be painted must be clean, dry and free of contaminants. Sandpaper with P180 – P220 abrasive paper and apply the primer on the treated surface. Before applying PITTURA PER COPERTA, blow with clean and dry air to remove any sanding or dirt residual. Wood: The moisture content of the wood must not exceed 18%. Thoroughly sandpaper with no. P80 P120...

PITTURA PER COPERTA TECHNICAL DATA SHEET Application data 703 - Roller/Brush(5% max) 703 - Conventional spray: (5% max) Conventional Pressure 3,5 bar Nozzle 1,2 – 1,4 mm Thinner/Tool cleaning Application methods Standard application range Standard application range Theoretical coverage Recommended primers Noxy - Defender Dry film thickness per coat Wet film thickness per coat Drying time Temperature °C Coverage Completely dry N.B. The drying times and the overcoating intervals increase with higher thickness of the applied film. Always check that the existing painting film is perfectly dry before...

PITTURA PER COPERTA TECHNICAL DATA SHEET CONDITIONS DURING APPLICATION In order to avoid the formation of condensation, the surface temperature should be at least 3°C above dew point. During application and curing, the min. ambient temperature must not be lower than 15° C or higher than 30° C, substrate temperature must not be lower than 10° C since the curing is remarkably reduced at lower temperatures. Application is not advisable when the relative humidity exceeds 80%. The term-hygrometric survey should be carried out near the surface to be coated. Make sure there is enough ventilation when...

PITTURA PER COPERTA TECHNICAL DATA SHEET Notes The values indicated in the present technical sheet can have slight variations from one batch to another. The applied product must not come in contact with water, chemicals or subjected to mechanical stress before the curing is complete. All wet film thicknesses refer to a product which is not diluted. With dilution, this value will rise. The above information is the result of accurate laboratory tests and practical experience; however, since the product is predominantly used outside the manufacturer’s control, Boero Bartolomeo S.p.A can only guarantee...