G-C Trailer
1 /4Pages

G-C Trailer

G-C Trailer
1 /4Pages

Catalog excerpts

G-C Trailer-1

boathandling systems The G-C Trailer is developed and constructed by professionals for boatyards and marinas. All types of boats - motor or sailing boats, regardless of hull form - can be handled. The trailer is constructed so that one person can easily handle it alone. The G-C Trailer has bogie-mounted wheels that make it go steady and safely also over rough ground. The G-C Trailer has a single axle design that make it easy to operate in narrow spaces both forward and backward. The G-C Trailer is constructed in steel for safe, uncomplicated and long-standing use for professionals with the highest demands. The G-C Trailer works together with most pallet systems but together with SteeiCradie/^^UIfiGA N, SteelBarStand/ and SteelStand/ you will have an unbeatable system.

 Open the catalog to page 1
G-C Trailer-2

BOATHANDLING SYSTEMS G-C Trailer • Hydraulically adjustable width and length. • The width is easily adjusted to the cradle you wish to straddle. • ydraulic belt tension and adjustment of the struts make it possible to handle H all types of boats. • he draw bar is adjustable in length which makes the handling on a ramp T easier as well as to operate in narrow spaces. • ll surfaces that are in direct contact with the boat are protected to avoid A scratches or other damages. In protection of the boat hull, a 150 mm wide shoulder harness with at detachable C-clamp is used. If you need further information,...

 Open the catalog to page 2
G-C Trailer-3

boathandling systemsG-C Trailer Max load The boat rests on the adjustable stem plate and a band sling at ' the rear. Lift sling (Maximum load 1 ton) Lift brackets The boat rests on front and rear sling (only for smaller/lightweight boats). The boat rests on a stem plate and lift brackets (for hulls with sharp angles).

 Open the catalog to page 3
G-C Trailer-4

boathandling systemsG-C Trailer TECHNICAL DATA Weight Maximum load Allocation of weight Lifting height, bogie Widening Adjustment of draw bar Stem plate (adjustment in height) Hydraulic system Working pressure Valves Belt Tension Width C€-signed Approximately 4,5 tons 15,0 tons 5 tons stem plate + 5 tons bogie Approximately 0,8 m (hydraulically operated) Approximately 0,8 m (hydraulically operated) Approximately 1,8 m (hydraulically operated) Approximately 1,0 m (hydraulically operated) Radio operated 170-200 Bar Ratio controlled Divisible with C-shackle Approximately 4,0 m (hydraulically operated) 150...

 Open the catalog to page 4

All BOATHANDLING SYSTEMS catalogs and brochures

  1. Catalog

    44  Pages

  2. Mast crane

    1  Page

  3. Boat Dolly

    1  Page

  4. SBS/MBS

    4  Pages

  5. SteelBarStand

    4  Pages

  6. SteelCradle

    6  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.