Catalogs >
BluefinLed >
SY48 Tank Mounted Weld In

SY48 Tank Mounted Weld In
3Pages

Catalog excerpts

WELDED INTO HULL AT ANGLE REQUIRED 0-5 DEGREE FROM HORIZONTAL 6-45 DEGREE FROM HORIZONTAL OPTIONS SILCONE GASKET STOPS WATER INGRESS INTO WELD IN CHAMBER LENS: 8mm BOROSILICATE WITH ANTI-STICK COATING REAR CABLE EXIT OPTION EXIT TO BE WATERPROOF USING 1P68 CABLE CLAND LIGHT ENGINE AND MOUNTING BOLTS ISOLATED FROM WELD IN CHAMBER AND HULL. SILCONE GASKET STOPS WATER INGRESS INTO WELD IN CHAMBER EXTERNAL FACE OF HULL SIDE CABLE EXIT OPTION EXIT TO BE WATERPROOF USING 1P68 CABLE CLAND VOID WITHIN WELD IN CHAMBER ALLOWS FOR ADDITIONAL CABLE TO BE STORED. 6 8 © 2014 COASTLINE LED. THIS DOCUMENT MUST NOT BE REPRODUCED IN WHOLE OR IN PART AND MUST NOT BE USED OR DISCLOSED WITHOUT THE WRITTEN AUTHORISATION OF COASTLINE LED. NO DEVIATION FROM THIS DRAWING IS PERMISSABLE WITHOUT WRITTEN AUTHORISATION FROM COASTLINE LED. TOLERANCES ON ALL DIMENSIONS UNLESS OTHERWISE STATED WHOLE UNITS: 0.25 ONE DECIMAL PLACE: 0.1 TWO DECIMAL PLACES: 0.05 ANGLES: 0.5 ALL UNSPECIFIED CHAMFERS: 1 x 45 BREAK ALL SHARP EDGES: 0.1 TO 0.5 THIRD ANGLE PROJECTION DESCRIPTION: ORCA WELD-IN MATERIAL:

Open the catalog to page 1

SHEET: 2 OF 3 SCALE: 1:1 @ A3 THIRD ANGLE PROJECTION © 2014 COASTLINE LED. THIS DOCUMENT MUST NOT BE REPRODUCED IN WHOLE OR IN PART AND MUST NOT BE USED OR DISCLOSED WITHOUT THE WRITTEN AUTHORISATION OF COASTLINE LED. NO DEVIATION FROM THIS DRAWING IS PERMISSABLE WITHOUT WRITTEN AUTHORISATION FROM COASTLINE LED. ALL DIMENSIONS ARE IN MILLIMETERS TOLERANCES ON ALL DIMENSIONS UNLESS OTHERWISE STATED WHOLE UNITS: +0.25 ALL UNSPECIFIED CHAMFERS: 1 x 45° BREAK ALL SHARP EDGES: 0.1 TO 0 DESCRIPTION: ORCA WELD-IN

Open the catalog to page 2

FULL PENETRATION WELD REQUIRED. BLE ARIAABLE L: V I ERIASS: VAR AT NE LM HUL THICK L HUL REAR CABLE EXIT. IP68 CABLE GLAND (NOT SHOWN) SIDE EXITING CABLE ALSO AN OPTION MATERIAL EXTERNAL TO HULL SACRIFICIAL AFTER WELDING, EXCESS MATERIAL TO BE BE DRESSED BACK TO BE FLUSH TO HULL. ADDITIONAL MATERIAL ON WELD IN CHAMBER ALLOWS FOR ADJUSTABILITY IN ANGLE OF INSTALLATION SECTION D-D ALL DIMENSIONS ARE IN MILLIMETERS 8 © 2014 COASTLINE LED. THIS DOCUMENT MUST NOT BE REPRODUCED IN WHOLE OR IN PART AND MUST NOT BE USED OR DISCLOSED WITHOUT THE WRITTEN AUTHORISATION OF COASTLINE LED. NO DEVIATION...

Open the catalog to page 3

SY48 Tank Mounted Weld In 3Pages

Catalog excerpts

All BluefinLed catalogs and brochures

SY48 Tank Mounted Weld In
3Pages