PRODUCT DATA SHEET HIGH BUILD EPOXY PRIMER D8002/D3002 or D9002/D3002 Features & Uses High Build Epoxy Primer is a two component epoxy surfacer for use where high build and filling is required. Not to be used below the waterline. In North America, D3002 is classed as a VOC Exempt Converter according to North American legislation. Using D3002 and T0176 the mixed ready to apply material has a VOC content of less than 2.8lbs/Gal or 340g/lt. Check with local authorities to determine VOC restrictions in your area. Specification Data Type: Epoxy Polyamide. Packaging: Available in 1 gallon and 1 quart containers. Theoretical Coverage: Sq. Feet/Gallon: 814 Sq. Feet (75.6 Sq. Meters) at one mil dry (25 microns). 111-157 Sq. Feet (10-15 Sq. Meters) at recommended dry film thickness with 2 coats. Calculated for mixed base and converter reduced 20%. Coverage calculations are based on theoretical transfer efficiency of 100%. Actual coverage rate obtained will vary according to equipment choice, application techniques, part size, and environment. Recommended Wet Film Thickness: 8-10 mils (200-250 microns) per coat. Recommended Dry Film Thickness: 4-5 mils (100-125 microns) per coat, 2-3 coats may be required. Recoatability: With itself: 2 hours; With other products: 12-24 hours. Maximum without sanding: 24 Hours. Sanding before over coating with other products is recommended. May be over coated with 545 Epoxy Primer, ULTRA BUILD, Sprayable Fairing Compound, AWL ®FAIR L.W., and AWL®QUIK. VOC: White Base (D8002) – 347 g/lt or 2.9 lbs/gallon Yellow Base (D9002) – 338 g/lt or 2.8 lbs/gallon Converter (D3002) – 361 g/lt or 3 lbs/gallon Converter (D3002) NA only – 331 g/lt or 2.8 lbs/gallon (This VOC applies to North America only). Product Components, Reducers, Additives, and Auxiliary Components

PRODUCT DATA SHEET HIGH BUILD EPOXY PRIMER D8002/D3002 or D9002/D3002 Airless Equipment Binks or equivalent Spray Gun: Airless 1 Orifice Size: .028” - .043” Fan Size & Angle: 8” – 80°, or 6” – 60° On a 25-1 pump, the pressure gauge should read 70 - 80 PSI On a 40-1 pump, the pressure gauge should read 50 - 60 PSI Product is not recommended for roll-and-tip application. Surface Preparation Best when used as a surfacer over other Awlgrip Primers and fairing compounds. May be applied directly to properly prepared wood or fiberglass; however, best results are obtained when these surfaces are first...