Product Data Sheet Awlfair Surfacing Filler D6200 / D3200 Uses Awlfair Surfacing Filler is a premium two-component epoxy product. It is a non-shrinking glazing filler applicable over Awlfair LW Fairing Compound where it is used to fill sand scratches, pinholes and surface imperfections. Awlfair Surfacing Filler gives an outstanding smooth finish prior to applying the sealing, high build or finish primer. Utilizing the same technology as Awlfair LW, Awlfair Surfacing Filler has outstanding solvent resistance. Specification Data Packaging: Available in 1HG pack (fill volume 1.89lts) base and 1QT pack (fill volume 0.946lts). Theoretical Coverage: All trademarks mentioned in this publication are owned by, or licensed to, the AkzoNobel group of companies. ©AkzoNobel 2015 Page 1 of 4 - Rev G - January 2015 - Awlfair Surfacing Filler AkzoNc

Product Data Sheet Awlfair Surfacing Filler D6200 / D3200 D Surface Preparation The surface preparation advice provided, and equipment suggestions, can be used as a guide. Preparation techniques and results will vary according to individual conditions, equipment age and other factors. Testing on a non-critical area should be carried out prior to full-scale preparation. Awlfair LW Fairing Compound should be sanded prior to application of the Awlfair Surfacing Filler. See the relevant product datasheet for more details H Mixing & Reduction Mixing and reduction requirements will vary according to...

Product Data Sheet Awlfair Surfacing Filler D6200 / D3200Recoatability and Drying Time The data given for recoatability is not exhaustive. Actual recoatability can vary according to individual conditions, climate and surroundings. If unsure consult local technical service representative before proceeding *Awlfair Surfacing Filler can be left for an unlimited time but must be sanded prior to overcoating. Once sanded Awlfair Surfacing Filler must be overcoated within 24 hours. **To achieve the optimum aesthetic result overcoat Awlfair Surfacing Filler with High Build Epoxy Primer before applying...

Product Data Sheet Awlfair Surfacing Filler Warning Notes: Do not add any thinners or reducers to Awlfair Surfacing Filler. Do not use unless mixed thoroughly with the converter at specified ratio. Do not thin. Do not wipe down cured filler with reducers. Do not use below 13°C/55°F or warmer than 40ºC/104°F. Proper application and/or cure results may be more difficult to achieve when conditions are outside this range. Avoid conditions of low temperature with high humidity as this can result in the formation of a surface byproduct that must be removed by either detergent wash followed by fresh...