(Spray) Intended Uses Awlgrip Topcoat (Spray) is a premium quality polyurethane high gloss finish, formulated to deliver a great appearance combined with excellent chemical resistance and hardness. Awlgrip topcoat has an easy mix ratio, and can be combined with a range of reducers for a flexible application providing incredible results. - Easy to apply long lasting finish - High gloss topcoat with outstanding DOI (distinction of Image) - Wide color range available on mixitcloud.com Specification Data Volume Solids Specific Gravity Available Packs Converter Reducer Equipment Cleaning Typical Shelf Life Theoretical Coverage Coverage calculations are based on theoretical transfer efficiency of 100%. Actual coverage rate obtained will vary according to equipment choice, thinning, application techniques, part size and application environment. All VOC information contained herein is theoretical (unless otherwise stated). Actual VOC content may vary by batch from one color to another and when tested via standard test methodology. Surface Preparation The surface preparation advice provided, and equipment suggestions, can be used as a guide. Preparation techniques and results will vary according to individual conditions, equipment choice/condition and other factors. Testing on a non-critical area should be carried out prior to full-scale preparation. For best results, Awlgrip Topcoat colors should be applied over properly prepared 545 Epoxy Primer. Awlgrip Topcoat colors may also be applied over recently applied Awlgrip Topcoats/showcoats - consult your local technical sales representative for advice. Awlgrip Topcoat High Gloss Clear (G3005) can be applied over dark Awlgrip Topcoat colors which have been sanded with 320-400 grit paper. Do not apply Awlgrip Topcoat (Spray) over white or pastel colours. Do not apply G3005 directly to bare wood. The primed surface must be clean and dry. Achieving maximum gloss and distinction of image requires the primer to be smooth sanded with 280-400 grit paper before topcoat application. Using a contrasting mist coat of lacquer primer as a "guide coat" is recommended. Smooth sanding until all of the "guide coat" is removed indicates a texture free surface. Mixing & Reduction Mixing and reduction requirements will vary according to individual conditions, climate, equipment choice/condition and other factors. Mixing and application of a small sample before full-scale application is recommended. Application Methods Mix by volume one part Awlgrip Topcoat base component with one part Awlcat #2 (G3010) spray converter to a smooth, homogenous mixture. Reducer addition level required to achieve 11-14 seconds viscosity DIN4 or equivalent (16-18 seconds viscosity Zahn 2) varies color to color. For standard air atomized application this can be attained by adding up to 33% reducer, using the correct spray reducer appropriate for conditions. Clear coats and painting in high temperature conditions may require additional reduction. (Spray) Issue Date: 20/09/2023

ProductMixData Sheet by volume one part Awlgrip Topcoat base component with one part Awlcat #2 (G3010) spray converter to a smooth, homogenous mixture. Reducer level required to achieve 11-14 seconds viscosity DIN4 or equivalent (16-18 seconds viscosity Zahn 2) varies color to color. For standard air atomized Awlgripaddition Topcoat (Spray) application this can be attained by adding up to 33% reducer, using the correct spray reducer appropriate for conditions. Clear coats and painting in high G/H Line temperature conditions may require additional reduction. Application Application equipment and...