Product Data Sheet Intended Uses Awlcraft CS is a two component, intermixable matt clearcoat designed for the yacht market, specially created to be applied on small and larger areas. Whether your boat requires a matt, satin or semi gloss finish, Awlcraft CS can do the job. Designed to complement the full range of colors and effects of the Awlcraft® SE basecoat. It can also be applied over Awlcraft 2000. Awlcraft CS, the perfect solution for a finish in any gloss level. Specification Data Volume Solids 46.4% Available Packs Base Equipment Cleaning 1 US Gallon (=3.78L) for Base and Curing Solution Awlcraft CS - Low Gloss Base (OJ0300) Awlcraft CS - Medium Gloss Base (OJ0301) Awlcraft CS - Curing Solution (OJ0010) Theoretical Coverage Coverage calculations are based on theoretical transfer efficiency of 100%. Actual coverage rate obtained will vary according to equipment choice, thinning, application techniques, part size and application environment. VOC All VOC information contained herein is theoretical (unless otherwise stated). Actual VOC content may vary by batch from one color to another and when tested via standard test methodology. Surface Preparation The surface preparation advice provided, and equipment suggestions, can be used as a guide. Preparation techniques and results will vary according to individual conditions, equipment choice/condition and other factors. Testing on a non-critical area should be carried out prior to full-scale preparation. For overcoating over Awlcraft SE Basecoat, please refer to Basecoat TDS. Awlcraft CS should be applied over Awlcraft SE Basecoat. Awlcraft SE Basecoat surface must be kept clean at all times before Awlcraft CS application. See Awlcraft SE Technical Datasheet for recommendations. Awlcraft CS can also be applied over sanded Awlgrip Topcoat, Awlgrip HDT and Awlcraft 2000. Over Awlgrip Topcoat/Awlgrip HDT/Awlcraft 2000 sand topcoat with P400 to remove the gloss and clean with Surface Cleaner T0170 (US/AP) or T0340 (EU) using the two cloth wipe down method. Do not use unless mixed thoroughly with the curing agent at specified ratio. Avoid painting in direct sunlight. Substrate temperature should be minimum 5°C/41°F and maximum 30°C/86°F. Product temperature should be minimum 15°C/59°F and maximum 35°C/95°F. Ambient temperature should be minimum 5°C/41°F and maximum 35°C/95°F. Avoid applying late in the evening as condensation can cause a loss of gloss during overnight cure. Allow to dry in a well ventilated environment. Mixing & Reduction Mixing and reduction requirements will vary according to individual conditions, climate, equipment choice/condition and other factors. Mixing and application of a small sample before full-scale application is recommended. Application Methods Mix ratio can also be calculated as follows: 2.5:1 by volume (Base:converter) and then add 40% thinner

Mixing and reduction requirements will vary according to individual conditions, climate, equipment choice/condition and other factors. Mixing and application of a small sample before full-scale application is recommended. Application Methods Recommended Thinning Spraying Viscosity Product Data Sheet Awlcraft CS Mix = Base:Converter:Thinner Mix ratio can also be calculated as follows: 2.5:1 by volume (Base:converter) and then add 40% thinner Application Application equipment and parameters are given as a guide. Actual equipment choices will vary according to application conditions, equipment condition...