Intended Uses Awlcraft 2000 is a two component, premium polyurethane finish that is easy to apply and delivers a high gloss finish in a wide range of colors with enhanced color and gloss retention. * Provides a buffable, high gloss finish * Fast drying and easy to apply * Can be used with a wide range of reducers for a flexible application Spray application only. Do not use below the waterline. Specification Data Volume Solids Specific Gravity Available Packs Base Equipment Cleaning 44.5% (average, unthinned) 1 US Gallon, 1 US Quart Awlcraft 2000 (range of colors) T0001 - Fast Evaporating Reducer-Spray T0002 - Very Fast Evaporating Reducer-Spray T0003 - Standard Reducer-Spray T0005 - Hot Weather Reducer - Spray OT0001, OT0002, OT0003 Theoretical Coverage Calculated for mixed base and converter, unthinned. Coverage calculations are based on theoretical transfer efficiency of 100%. Actual coverage rate obtained will vary according to equipment choice, thinning, application techniques, part size and application environment. VOC All VOC information contained herein is theoretical (unless otherwise stated). Actual VOC content may vary by batch from one color to another and when tested via standard test methodology. Typical VOC for Awlcraft 2000 Bases range between 413 and 486 g/L. VOC for mixed, unthinned product range between 472 and 520 g/L. Surface Preparation The surface preparation advice provided, and equipment suggestions, can be used as a guide. Preparation techniques and results will vary according to individual conditions, equipment choice/condition and other factors. Testing on a non-critical area should be carried out prior to full-scale preparation. Best results are achieved when sprayed over properly prepared 545 Epoxy Primer, Quick Build or 321 HS Undercoat. May be applied directly over some existing finishes. The existing finish must be sound, tightly adhered to the substrate, and chemically compatible with Awlcraft 2000.. Mixing & Reduction Mixing and reduction requirements will vary according to individual conditions, climate, equipment choice/condition and other factors. Mixing and application of a small sample before full-scale application is recommended. Application Methods Mix by volume two parts Awlcraft 2000 Base with one part Awlcat #2 (G3010) Spray Converter to a smooth, homogenous mixture. Reducer addition level required to achieve 11-14 seconds viscosity DIN4 or equivalent (16-18 seconds viscosity Zahn 2) varies color to color. For standard air atomized application this can be attained by adding up to 33% reducer, using the correct spray reducer appropriate for conditions. Clear coats and painting in high temperature conditions may require additional reduction. For example, if a 25% reduction is used, overall mix is 2:1:% by volume (8 oz. Base, 4 oz. G3010, 3 oz. Reducer or 2L Base, 1L G3010, 0.75L Reducer). Awlgrip, the AkzoNobel logo and other prod ucts mentioned in thus publication are trademarksofAkzoN obel. ©AkzoNobel 2022

Mix by volume two parts Awlcraft 2000 Base with one part Awlcat #2 (G3010) Spray Converter to a smooth, homogenous mixture. Reducer addition level required to achieve 11-14 seconds viscosity DIN4 or equivalent (16-18 seconds viscosity Zahn 2) varies color to color. For standard air atomized application this can be attained by adding up to 33% reducer, using the correct spray reducer appropriate for conditions. Clear coats and painting in high temperature conditions may require additional reduction. Product Data Sheet Awlcraft 2000 For example, if a 25% reduction is used, overall mix is 2:1:¾...