PRODUCT DATA SHEET AWL®CARE PROTECTIVE POLYMER SEALER 73240 Features & Uses AWLCARE is a hand-applied, non-abrasive, synthetic polymer formulated to protect AWLGRIP®, AWLCRAFT® 2000, and AWLGRIP 2 topcoats. AWLCARE contains no harsh abrasives and will not scratch the painted surface. It leaves a non-yellowing, protective polymer coating which lasts through multiple washings. AWLCARE removes mild stains such as water spots and diesel soot, and increases resistance to attack from acid rain and other environmental pollutants with regular applications. Specification Data Type: Protective Polymer Sealer. Packaging: Pint (.473 Liters) and Half Gallon (1.872 Liters). 2 Theoretical Coverage: One pint (.473 Liters) will cover 450 Sq. Feet (42m ) with one coat. Two coats are recommended for initial application. VOC: 230 g/l or 1.92 lbs/gallon. Application Equipment Apply with a 100% cotton applicator or cloth. Do not apply AWLCARE with mechanical devices, apply by hand only. Surface Preparation Wash surface with AWL®WASH Wash Down Concentrate (73234), rinse and wipe dry. Mixing & Reduction Shake AWLCARE well before applying. Application Instructions Shake AWLCARE well and apply with a 100% cotton applicator or cloth. AWLCARE can be applied in sun or shade, and can be applied to large areas before removing. Do not apply AWLCARE with mechanical devices. Allow AWLCARE to dry to a haze. Wipe off haze with a 100% clean, cotton cloth. Note: Awlgrip recommends washing the surface once a week to prevent dirt build up. Use AWLWASH Wash Down Concentrate (73234) to minimize removal of the AWLCARE Protective Polymer Sealer. Multiple coats of AWLCARE may be needed to protect water run-off areas. Please reference Awlgrip’s website www.awlgrip.com for further information regarding care and maintenance of Awlgrip products. All trademarks mentioned in this publication are owned by, or licensed to, the AkzoNobel group of companies. ©AkzoNobel 2015 Page 1 of 2 • Rev 4 – January 2015 • AWL®CARE PROTECTIVE POL

PRODUCT DATA SHEET AWL®CARE PROTECTIVE POLYMER SEALER 73240 Warning: Keep container tightly closed and upright to prevent leakage. Keep container closed when not in used. Keep from freezing. Temperature Range: Optimal Surface/Ambient Temperature range is 18°C (60°F) to 35°C (95°F). Proper Application and/or cure results may be more difficult to achieve when conditions are outside this range. Do not apply paint materials to surfaces less than 3°C or 5° F above dew point. Do not apply paint materials to surfaces warmer than 41°C (105°F). Ambient temperature should be minimum 10°C (50°F) and maximum...