Catalog excerpts
Product Data Sheet Awlcare Intended Uses Awlcare is a handapplied, nonabrasive, synthetic polymer formulated to protect AWLGRIP®, AWLCRAFT® 2000, Awlcraft SE and Awlgrip HDT topcoats. Awlcare contains no harsh abrasives and will not scratch the painted surface. It leaves a non-yellowing, protective polymer coating which lasts through multiple washings. Awlcare removes mild stains such as water spots and diesel soot, and increases resistance to attack from acid rain and other environmental pollutants with regular applications. Specification Data Available Packs Base Typical Shelf Life 1 US Pint, ½ US Gallon 73240 2 years Theoretical Coverage Application Methods Theoretical Coverage Per Coat (at recommended DFT) Cloth One pint (.473 Liters) will cover 450 Sq. Feet (42m2) with one coat. Two coats are recommended for initial application. Coverage calculations are based on theoretical transfer efficiency of 100%. Actual coverage rate obtained will vary according to equipment choice, application techniques, part size and application environment. VOC All VOC information contained herein is theoretical (unless otherwise stated). Actual VOC content may vary by batch and when tested via standard test methodology. Product As Supplied (without reducer) g/l Surface Preparation Wash surface with AWLWASH Wash Down Concentrate (73234) NA & AP - Awlwash 2.0 (73235) EU, rinse and wipe dry. The surface preparation advice provided, and equipment suggestions, can be used as a guide. Preparation techniques and results will vary according to individual conditions, equipment choice/condition and other factors. Testing on a non-critical area should be carried out prior to full-scale preparation. Mixing & Reduction Shake well before use. Mixing and reduction requirements will vary according to individual conditions, climate, equipment choice/condition and other factors. Mixing and application of a small sample before full-scale application is recommended. Application Shake Awlcare well and apply with a 100% cotton applicator or cloth. Awlcare can be applied in sun or shade, and can be applied to large areas before removing. Do not apply Awlcare with mechanical devices. Use Awlwash Wash Down Concentrate (73234) NA & AP - Awlwash 2.0 (73235) EU to minimize removal of the Awlcare Protective Polymer Sealer. Wipe off haze with a 100% clean, cotton cloth. Multiple coats of Awlcare may be needed to protect water run-off areas. Note: Awlgrip recommends washing the surface once a week to prevent dirt build up. Wash surface with AWLWASH Wash Down Concentrate (73234) NA & AP - Awlwash 2.0 (73235) EU, rinse and wipe dry. Application equipment and parameters are given as a guide. Actual equipment choices will vary according to application conditions, equipment condition and other factors. Testing on a non-critical area should be carried out prior to full-scale application. Contact your local technical service representative for further advice if necessary. Recoatability & Drying Times The data given for recoatability is not exhaustive. Actual recoatability can vary according to individual conditions, climate and surroundings. If unsure, consult your local technical service representative before proceeding. Please refer to your local representative or visit http://www.awlgrip.com for further information. Awlgrip, the AkzoNobel logo and other products mentioned in this publication are trademarks of AkzoNobel. ©AkzoNobel 2019 1 of 2 Ref:4076 Awlc
Open the catalog to page 1Application equipment and parameters are given as a guide. Actual equipment choices will vary according to application conditions, equipment condition and other factors. Testing on a non-critical area should be carried out prior to full-scale application. Contact your local technical service representative for further advice if necessary. Product Data Sheet Awlcare Recoatability & Drying Times The data given for recoatability is not exhaustive. Actual recoatability can vary according to individual conditions, climate and surroundings. If unsure, consult your local technical service...
Open the catalog to page 2All Awlgrip catalogs and brochures
-
545
2 Pages
-
AWLBRITRE
2 Pages
-
Awlcraft SE
3 Pages
-
AWL®FAIR L W FAST CURE
2 Pages
-
MAX COR CF 2K AEROSOL
3 Pages
-
AWL®COAT TPC
2 Pages
-
Wash Primer CF
2 Pages
-
HIGH BUILD EPOXY PRIMER
2 Pages
-
Hullgard Extra Epoxy Primer
2 Pages
-
Satin Matt
3 Pages
-
Griptex
3 Pages
-
Awlgrip Topcoat
2 Pages
-
Crater-X
2 Pages
-
Awlfair LW
3 Pages
-
Awlfair Pumpable
2 Pages
-
Surface Cleaner
2 Pages
-
Awlwood Clear Gloss
7 Pages
-
Awlwood MA Spray Reducer
9 Pages
-
Awlwood MA Clear Gloss Gloss
9 Pages
-
Awlwood MA Primer Clear
9 Pages
-
Awlgrip HDT Clearcoat
2 Pages
-
D3200 D6200
4 Pages
-
Awlfair LW Fast US
2 Pages
-
Awlcoat TPC
2 Pages
-
Awlbrite Semi Gloss
2 Pages
-
Alumiprep 33
1 Pages
-
Awlgrip Paint Accessories
5 Pages
-
Awlwood
5 Pages
-
Awlcare
2 Pages
-
Awlwash
2 Pages
-
Awlfair LW fast EU
2 Pages
-
345 HS PRIMER
3 Pages
-
321 HS UNDERCOAT
3 Pages
-
FLATTENING AGENT G3013
2 Pages
-
AWLGRIP® Topcoats G/H Line
3 Pages
-
Awlcraft SE
3 Pages
-
AWLCRAFT 2000 METALLICS
3 Pages
-
Activators
2 Pages
-
345HS Primer
3 Pages
-
Awlcraft 2000 VOC
2 Pages
-
Pro-Cure
2 Pages
-
Awlstar Gold Label antifouling
2 Pages
-
AWL ® STAR GOLD LABE
2 Pages
-
REDUCERS
3 Pages
-
Awlfair Surfacing Filler
3 Pages
-
HULLGARD EPOXY PRIMER
2 Pages
-
Flat Bl ack A wlgrip ®
2 Pages
-
STANDARD E TROWELABLE
2 Pages
-
Max Cor CF Primer
2 Pages
-
Awlbrite Quick-Fil
2 Pages
-
AWLGRIP
6 Pages
-
CF 2K
3 Pages
Archived catalogs
-
545 CLEAR EPOXY PRIMER
2 Pages
-
HULLGARD EXTRA EPOXY PRIMER
2 Pages
-
AWL®COAT TPC
2 Pages