*mynauticexpo

Catalogs
Awlgrip
Awlbrite Quick-Fil

Awlbrite Quick-Fil

Product catalog summary

Features & Uses
Awlbrite Quik-Fil Clear is a fast-drying wood grain filler designed for interior wood surfaces. It provides excellent film build and adhesion, allowing for recoating without sanding. It must be finished with varnishes or urethane topcoats from Awlgrip.

Specification Data
Type: Aromatic isocyanate polyurethane
Color: Clear
Packaging: Available in gallons and quarts
Theoretical Coverage: 392ft² (spray) and 410ft² (brush) per gallon
Recommended Film Thickness: 3-3½ mils wet, 1-1½ mils dry
Number of Coats: 1-2 for open grain, 4-5 for flush filled surfaces
Drying Time: 30 minutes touch dry, 3 hours hard dry
Recoatability: 3 hours minimum, 48 hours maximum without sanding
VOC: J3901 395g/lt, J3902 726g/lt

Product Components
Base: J3901
Converter: J3902
Reducer: T0001, T0003, T0031
Cleaning: T0001, T0003, T0031, or M.E.K.

Application Equipment
Conventional Spray: Tip size 0.070” or 1.5 mm, pressure 50-60 psi
Brush: Reduce 25-50% using T0031 for bare wood saturation

Surface Preparation
Ensure wood is clean, dry, and smooth. Use marine teak cleaner or wood bleach for new wood. Sand with 150-180 grit paper in the direction of the grain. Not suitable for previously painted surfaces.

Mixing & Reduction
Mix 1 part J3901 base with 1 part J3902 converter. For brushing, add ¼ of T0031 for the first coat. Pot life is 3 hours at 77°F/25°C.

Application Instructions
Apply by spray or brush, with the first coat best applied by brush. Reduce the first coat 25-50% with T-series reducer. Sand between coats for a smooth finish.

Warnings
Do not apply to surfaces less than 3°C above dew point or warmer than 41°C. Ambient temperature should be between 13°C and 41°C.

Disclaimer
The information is subject to change and should be verified for suitability before use. Awlgrip® is a trademark of Akzo Nobel.

Catalog excerpts

PRODUCT DATA SHEET AWLBRITE QUIK-FIL CLEAR J3901/J3902 Surface Preparation The wood should be clean, dry, smooth and well seasoned. New wood: remove excess oils by using a marine teak cleaner or wood bleach. This will promote color uniformity and adhesion. Thoroughly remove all cleaner and neutralizer residue before proceeding. Sand to level the grain using 150 – 180 grit paper. Always sand in the direction of the grain. Remove any sanding residue prior to application. Awlbrite Quik-Fil Clear is not suitable for application on previously painted surfaces. Note: Due to the wide variety of substrates,...

Open the catalog to page 2

All Awlgrip catalogs and brochures

Archived catalogs

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list