PRODUCT DATA SHEET AWLGRIP 545 CLEAR EPOXY PRIMER D3020 / D3001 Features & Uses 545 Clear Epoxy Primer is a high performance two component sealer ideal for use on carbon fiber and wood constructions. The product provides a good build coat and may be recoated with Awlgrip Urethane clears or varnishes where UV protection is required. Specification Data Type: Epoxy Polyamide Color: Clear Packaging: Available in 1 gallon containers. Theoretical Coverage: Sq. Feet / Gallon based on mixed base and converter thinned 25% with T0006 315 Sq. feet at 1 mil dry (29m 2 2 at 25 micron dry). 135 - 180 Sq. feet (12.5 – 16.7m ) at recommended dry film thickness (3 coats) Coverage calculations are based on theoretical transfer efficiency of 100%. Actual coverage rate obtained will vary according to equipment choice, application techniques, part size, and application environment. Recommended Wet Film Thickness (spray or brush): 3 - 4 mils (75 - 100) per coat Recommended Dry Film Thickness (spray or brush): 0.5 - 0.75 mils (15 - 20 microns) per coat Number of coats: 2 - 3 coats required Recoatability at 77°F/ 25°C, 50% RH: Spray: Minimum with itself 1 hour, with other products 12 hours. Brush/ Roller: minimum with itself 12 – 14 hours, with other products 12 – 14 hours. Maximum without sanding: 24 hours. Sanding is recommended to improve adhesion and appearance. Recoat with Awlgrip High Gloss Clear , Awlcraft 2000 High Gloss Clear, Awlbrite Clear Gloss or Semi-gloss, Awlspar varnish, Awlspar High Solids Varnish, 545 and Awl-Quik. VOC: Base: 678 g/lt or 5.66 lbs/gallon Converter: 616g/lt or 5.15 lbs/gallon Mixed: 689 g/lt or 5.74 lbs/gallon All trademarks mentioned in this publication are owned by, or licensed to, the AkzoNobel group of companies. ©AkzoNobel 2015 Page 1 of 2 - Rev 2 – January 2015 - 545 CLEAR EPOXY PRIMER

PRODUCT DATA SHEET AWLGRIP 545 CLEAR EPOXY PRIMER D3020 / D3001 Application Equipment Conventional spray and brush / roller. Spray equipment as follows: Air Atomized Siphon or Cup System Binks or equivalent: Spray gun: #95 Fluid nozzle: #66SS (.070” Orifice size) Fluid needle: #665 Air nozzle: #66SK Atomizing air pressure should be approx. 50 – 60 lbs. Pressure Pot System Guns Binks or equivalent Spray gun: #95 Fluid nozzle: #63BSS (.046” Orifice Size) Fluid needle: #663A Air nozzle: #63PW Pressure Pot gauge should read 8 – 12 lbs with 50-60 lbs atomization. Surface Preparation Wood/ Composite:...