EVO_II_QUICK_GUIDE
16Pages

Now you can explore, discover and create like never before. The EVO II delivers not only advanced features like obstacle avoidance and intelligent flight modes, but also high-tech muscle that brings home a top speed of 44mph, 35-minute flight hover time, 40-minute flight time and an operating 5.6 In-flight performance, however, is just the start. The EVO IPs stabilized 3-axis camera allows you to shoot at up to 8K/25 fps, and view the live feed at up to 1080p on your mobile device or the remote control’s built-in OLED screen. Welcome to the Autel Robotics family. Use this guide to get an...

® Propellers (|) Motors © Front LED Indicators @ Landing Gear © Forward Vision System © Camera Gimbal ® Power Button © Rear LED Indicators ® Rear Vision System ® Left Vision System ® SD Card Port

® Right Vision System © Aircraft Battery ©Remote Control Pairing Button/Pairing Indicator ® Ultrasonic Sensor © Downward Vision Lighting LED © Downward Vision System

A LED indicator is located on the end of each aircraft arm. The front LEDs will light up solid red to help you identify the direction of the aircraft's nose. The rear LEDs will display the current flight status of the aircraft. The chart below shows the meaning of each status indicator. Color Key: R — Red Color Y —Yellow Color G — Green Color Indicator Key: Slow Flashing: Flashes once every 2s Fast Flashing: Flashes twice per second Double Flashing: Flashes twice and then pauses and repeats Alternate Flashing: Alternates among different colors Example: “R - Solid Light” means solid red light.

R - Solid Light Calibration is failed Gesture Commands R - Fast Flashing Gesture command has been received © Mobile Device Holder ® Flight Information Panel © Command Sticks © Hand Grips © Take-off/Landing Button © Power Button © USB Ports ® Pause Button © Go Home Button ® Antennas With a 180° adjustable viewing angle for optimum visibility Displays the flight status, warning messages and live video feed Control the orientation and movement of the aircraft Foldable to allow for compact storage Commands the aircraft to take off or land Press and hold the button for 2 seconds to turn on/off...

© Screen Navigation Dial @ Screen Navigation Button ® Shutter Button ® Button A © Button B ® Record Button @ Gimbal Pitch Dial Scrolls around the OLED screen When the mobile device is disconnected, press this button for 1 second to enter/exit the Image Transmission screen on the remote control Takes photos. When Burst Mode is turned on, several images will be taken with one press. For details, see the App Manual. Function can be set using the Autel Explorer™ app Function can be set using the Autel Explorer™ app Starts or stops recording video Controls the pitch angle of the camera gimbal 6....

1) Aircraft Battery: Plug the charging connector into the battery’s charge port. 2) Remote Control: Open the protector on the USB port and plug in the provided charging cable. NOTE • Always fully charge the aircraft and remote control battery before flying. • It takes approximately 90 minutes to fully charge the aircraft battery, and 180 minutes to charge the remote control. 7. INSTALLING THE AUTEL EXPLORER™ APP(OPTIONAL) The Autel Explorer™ app delivers a live stream, and enhanced flight and camera controls to your mobile device. Follow the steps below to get connected. NOTE: Autel...

A IMPORTANT Power off the aircraft before folding it. Fold in the rear arms and propellers first, and then the front arms. 9. INSTALLING NEW PROPELLERS Because the propellers come attached to the aircraft, the following instructions apply if you need to reinstall propellers. Propellers must be undamaged and firmly attached. The white-coded propellers should be paired with the white-coded motors. • Attaching the Propellers 1). Verify that the aircraft is powered off. 2). Locate and match the propeller to each motor. 3). Press each propeller down firmly and rotate in the lock direction to...

Legend /0* Lock Direction: Fasten the propeller by rotating it as indicated. ‘S Unlock Direction: Unfasten the propeller by rotating it as indicated. Black-coded propeller > Pairs with > Black-coded motor White-coded propeller > Pairs with > white-coded motor A WARNING Power off the aircraft before attaching or detaching propellers. A MPORTANT Wear protective gloves when attachling or detaching propellers. 2). Position the antennas vertically in order to ensure the strongest possible signal. 9

I.Tum on the remote control. Press and hold the power button for 2 seconds. 2. Turn on the aircraft. Press and holder the aircraft power button for 3 seconds. The current battery level will be clearly displayed. 12. TAKEOFF 1. Place aircraft on a level surface. Stand well clear of the rear of the aircraft. 2. Start the motors by holding both command sticks for two seconds in one of these positions: NOTE: Before takeoff, place the aircraft on a flat and level surface and face the rear side of the aircraft towards you.

© 2020-2021 Autel Robotics Co., Ltd. All Rights Reserved