APCE-2000
3Pages

SMART PRESSURE TRANSMITTER APCE-2000 ü 4…20 m A output signal + HART protocol ATEX Intrinsic safety Gold plated diaphragm (Au) The APCE-2000 pressure transmitter is applicable to the measurement of the pressure, underpressure or absolute pressure of gases, vapours and liquids. The active sensing element is a piezoresistant silicon sensor separated from the medium by a diaphragm and by specially selected type of manometric liquid. Economical version: Version designed to work in hard conditions: - housing 304ss - protection IP65 - electrical connection DIN EN 175301-803 - the electronics encased in a protective silicon gel - housing material: 304SS - protection IP66 - the electronics encased in a protective silicon gel - cup with knurled handgrip G1/2 type G1/2", Ć4 hole M type M20×1.5, Ć4 hole 1/2’’NPT M type 1/2’’NPT male + internal thread G1/4’’ 1/2’’NPT F type internal thread 1/2-14NPT GP type G1/2", Ć12 hole P type M20×1.5, Ć12 hole GP type P type 1/2"NPT M type for HS version CG1 type G1" with flush diaphragm CG1/2 type G1/2" with flush diaphragm Version with direct or remote diaphragm seal Diaphragm seal data see chapter III Comunication and configuration The communication standard for data interchange with the The data interchange with the transmitter enables users to: transmitter is the Hart protocol. ¨ identify the transmitter Communication with the transmitter is carried out with: ¨ configure the output parameters: - measurement units and the values of the start points and end – a KAP-03, KAP-03Ex communicator points at the measurement range – some other Hart type communicators,(*) - damping time constant – a PC using an HART/USB converter and Raport 2 - conversion characteristic (inversion, user's non-linear configuration software. characteristic) (*) .eddl files available on www.aplisens.com. ¨ read the currently measured pressure value of the output current and the percentage output control level ¨ force an output current with a set value ¨ calibra

Installation The transmitter is not heavy, so it can be installed directly on the installation without additional mounting bracket. When the pressure of steam or other hot media is measured, a siphon or impulse line should be used. The needle valve placed upstream the transmitter simplifies installation process and enables the zero point adjustment or the transmitter replacement. When the special process connections are required for the measurement of levels and pressures (e.g. at food and chemical industries), the transmitter is provided with an Aplisens diaphragm seal. Installing...

Ordering procedure Model APCE-2000 Casing, output signal, electrical connection Versions, certificates Description Smart pressure transmitter Housing IP65 with DIN EN 175301-803 connector, without display, output 4-20mA + Hart 304SS housing, IP66, without display, output 4-20mA + Hart packing gland M20x1,5 II 1/2G Ex ia IIC T4/T5/T6 Ga/Gb II 1D Ex ia IIIC T110°C Da I M1 Ex ia I Ma PED category I not available for transmitters with Hastelloy C 276 wetted parts more than one option is available Nominal measuring range Process connections Ultra stable version (only ranges no. 3÷19, process...