28 ST E1
1Pages

{{requestButtons}}

Catalog excerpts

28 ST E1 - 1

2 speed manual, 1 speed electric, 12VDC Andersen Powered Winch: RA2028011300, RA2028001300 28 ST E1 - Self tailing, E1 electric motor, 2 speed manual, 1 speed electric, 12VDC Product Information: Power Ratio Gear Ratio Maximum Working Load Physical Dimensions: PUSH BUTTON Wiring Diagram: CIRCUIT BREAKER WINCH MOTOR Full installation dimensions can be found in the Product Manuals available to download at www.andersenwinches.com. Motor units are supplied with installation manual, push button and cable terminals. Circuit breaker available separately. See motor unit product manual for push button to motor unit cable connection details. Electrical Installation: WIRE SIZE FUSE or START-UP CIRCUIT MOTOR 2 BREAKER CURRENT 3 150A 1 Wire length = length from battery to motor and back to battery. 2 Must be a ‘slow blow’ or ‘long delay’ type to allow for start-up current spike. Suitable circuit breakers available separately. 3 The current “spike” generated at motor start-up, for a period of no more than 0.1 seconds. 4 This is the minimum additional Ah (Ampere hours) battery capacity that will be required to run one winch. Assuming a single winch, used for of 15 minutes (0.25hr) per day at a load of 1/2 MWL = 150A. This equates to an Ah figure of 38Ah. The number of Ah for all other electrical equipment ADDITIONAL MINIMUM BATTERY BATTERY CAPACITY BANK 4 PER WINCH CAPACITY 5 114Ah must be added to this figure to determine the Ah requirement of the total battery bank capacity. A good rule of thumb is to use 3 x this total Ah figure as the minimum additional battery capacity for your battery bank. We recommend you contact a qualified marine electrician for advice. 5. This is the minimum recommended battery bank capacity to ensure minimum 10.5V is maintained in 12V systems, and 21V in 24V systems at start up current. Based upon battery CCA value at -18C and assuming fully charged batteries and no losses in wiring and connections. LINE SPEED m/min (ft/min) LOAD kg (lb) The motor will cut-out at pre-determined current and temper

Open the catalog to page 1

All Andersen catalogs and brochures

  1. 50 ST E1

    1 Pages

  2. 46ST E1 12V

    1 Pages

  3. 40 ST E1

    1 Pages

  4. 34 ST E1

    1 Pages

Archived catalogs