Catalog excerpts
Wirewound (Bushingmount Servomount) ALTHEN SENSORS & CONTROLS 20HP ■ Standard dimensions Bushingmount type Servomount type 020 ± 1 ■ Standard Model Nos. Bushingmount type: 20HP-5S (5-turn) 20HP-10S (10-turn) ■ General Specifications Standard Resistance Range: Max. Practical Resistance Value: Total Resistance Tolerance: Independent Linearity Tolerance: Power Rating: Noise: Electrical Travel: Mechanical Travel: Insulation Resistance: Dielectric Strength: Starting Torque: Stopper Strength: Max. Working Voltage: Resist. Temperature Coefficient of Wire: Mass: 360° Xn +1 0 (n: No. of turns) Over 100 MQ at 1,0000 V.D.C. 1 minute at 1,000 V.A.C. Within 5mN-m (50gf^cm) (Bushingmount type) Within 3mN-m (30gf-cm) (Servomount type) Approx. 0.9N-m (9kgf-cm) (Bushingmount type) Approx. 0.6N^m (6kgf-cm) (Servomount type) 900V ±20p.p.m./°C Approx. 25g (5-turn) Approx. 30g (10-turn)
Open the catalog to page 1
SENSORS & CONTROLS ■ Standard Resistance Values | No. Of Wire Turns | Resistance Wire Used Resist. Value (0) 100 200 500 1k__2k 5k 10k 20k 50k 100k Resist. Wire Used Cu-Ni System I Ni-Cr System Note: Mark % shows value at special higher practical resistance ■ Special Specifications Available 3-turn type (S20HP-3S), lower resistance values (10Q, 20Q, 50Q), extra taps (available up to 1 tap), multi-ganged (available up to 2 gangs), shaft with front and rear extension (rear shaft with 2mm dia. and 10mm length), shaft dia. (06.35mm) • bushing with inch dimensions, special machining on the...
Open the catalog to page 2All Althen Controls catalogs and brochures
-
H25JB1 Pages
-
HE1 Series10 Pages
-
HE2 Series9 Pages
-
HE3 Series11 Pages
-
Model 30JH2 Pages
-
12HP2 Pages
-
10HP2 Pages
-
22HP2 Pages
-
OF46HD-102 Pages
-
OF501 Pages
-
Model 30JB2 Pages
-
Model H30JH2 Pages
-
MR Series6 Pages
-
MH Series7 Pages
-
TS1 Series5 Pages
-
TS2 Series3 Pages
-
Maritime Industry Brochure8 Pages
