Eliprimer 1COne component primer for propellers Special one-component primer for direct application onto metals such as brass, bronze, aluminium and steel. It can be overcoated with one or two component paints and in particular, for boat propellers, with CONTENDER ELICHE antifouling. Provides excellent adhesion onto the substrate as well as for the following coats Application temperature Relevant humidity Dry film thickness advised Theoret. coverage m2/Lt Between +10 C and +40 C Less than 80% SURFACE PREPARATION AND APPLICATION PROCEDURE METAL (BOAT PROPELLERS) Degrease the surface with a suitable solvent (nitro, epoxy or polyurethane based. Sandblast if possible or in alternative sand with? coarse grain sandpaper (80-100 grit). The substrate should have a suitable anchor pattern. Do not use old sandpaper or wire brush as they may? cause a polished? substrate and reduce the anchor properties for the primer application. Remove dust? with a dry vacuum cleaner. Avoid touching the surface with hands in order not? ?to leave traces of grease or dirt which could impair the application. Apply a first? coat of ELIPRIMER 1C allowing the recommended waiting time between coats. Wait from a minimum of 4 hours to a maximum of 12 hours (20?C) and overcoat? with a first coat of CONTENDER ELICHE antifouling. Apply a second coat of CONTENDER ELICHE antifouling? ?within 4 hours? ? ?from the application of the previous coat. Launch? into water after a minimum of 24 hours. (2^colori)'aemmeS_ DaM94^ AEMME COLORI SRL, Via Patta 12, 24020 Ranica (BG), Italy Tel: +39 035.513373- Fax: +39 035.513211 - Mail: [email protected]

Eliprimer 1C SAFETY PRECAUTIONS Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff. The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products...