Codice: B65514 Costiera T.F. Hard matrix antifouling Hard matrix, high performance antifouling formulated with high copper content and special ingredients for use on any sea. Provides appropriate protection to the hull once applied over a suitable primer. It can be applied on wood, steel and fibreglass hulls with speed also over 30 knots. Not suitable for aluminium boats. Techical Characteristics Binder type A Resins-Acrylic copolimers Specific gravity kg/lt (±0,05) 1.90-2.0 according to colour Viscosity Ford 0 8 at 20°C ±2 10-14 sec. Shelf life +23°C (±2) 36 months in unopened cans Launching time Min 24-48 hours Recoat time 8 hours (20°C) Application temperature Between +10 C and +40 C Relevant humidity Less than 80% Dry film thickness advised 60-90 microns per coat Theoret. coverage m2/Lt 5-8 SURFACE PREPARATION AND APPLICATION SYSTEMBare steel. Apply 1 coat of EPOFOND AM-9 on sandblasted steel according to SA 2,5 and let dry for 12-24 hours. (If sandblasting is not possible proceed with mechanical cleaning to bring the surface to bare steel, apply 1 coat of EVIOX CROMOMINIO and let dry for 8-12 hours.) Apply then 2 coats of SOLVER PRIMER allowing 24 hours between coats. Overcoat then with 2 coats of COSTIERA TF? antifouling allowing min.8 hours between coats. Bare wood.? ?Apply one coat of EVIOX CROMOMINIO and allow to dry for 8-12 hours. Apply 2 coats of SOLVER PRIMER allowing 24 hours between coats followed by 2 coats of COSTIERA TF? ?antifouling allowing min. 8 hours between coats.? ? Painted hull. ? If the old antifouling is still in sound conditions, compatible, and well sticked on the substrate, it is enough to apply 1-2 coats of SOLVER PRIMER followed by 2 coats of COSTIERA TF? antifouling, allowing the required waiting time between coats.? Fiberglass. ?Degrease with suitable cleaner and rinse with water the surface to be coated. Sand with fine abrasive paper and remove dust. Apply 1 coat of POLIFIBER PRIMER and after 24 hours sand with fine abrasive paper. Apply then 2 coats of COSTIERA TF WHITE antifouling allowing min.8 hours between coats.? AEMME COLORI SRL, Via Patta 12, 24020 Ranica (BG), Italy Tel: +39 035.513373 - Fax: +39 035.513211 - Mail: [email protected]

?N.B. as an alternative to POLIFIBER it is possible to use EPOFOND AM9 in the same conditions. Recommendations. ? After the application of the last coat the maximum launching period of the antifouling is 1 month; with top quality copper based antifouling and after agreement with our technical staff, the launching time may extend up to 3 months, providing that the hull is protected from moisture, rain or atmospheric agents with plastic cover or similar material. Colour. ?The color of the antifouling paint after immersion in water may result slightly different since small color differences can...