カタログ >
Sigma Coatings PPG PMC >
SIGMA ECOFLEET 238 A

SIGMA ECOFLEET 238 A
1 / 3ページ

カタログの抜粋

TBT-free selfpolishing antifouling PRINCIPAL CHARACTERISTICS - economical antifouling for commercial marine use - contains a specially balanced level of cuprous oxide for prevention of fouling - compatible with a wide range of anticorrosive underwater hull system - suitable on coated steel hulls on seagoing vessels, workboats and barges Mass density Volume solids Recommended dry film thickness Theoretical spreading rate Overcoating interval Shelf life (cool and dry place) redbrown, brown - flat 312 g/ltr (2.5 lb/gal) (by EPA Method 24) 75- 125 urn per coat depending on system SUBSTRATE CONDITIONS AIRLESS SPRAY Recommended thinner Nozzle orifice Nozzle pressure substrate temperature should be at least 3°C above dew point dependent upon condition of hull and existing antifouling, surface cleaning will vary from high pressure water cleaning to abrasive blasting existing fouled surfaces: • remove fouling by scraping and/or sweep blast • loose paint should be removed by high pressure water wash • tighty adhering anticorrosive and antifouling coating may remain for touch-up and repair; apply additional material after removing dirt, contaminants and old loose coatings or antifoulings stir well before use the temperature of the paint should preferably be above 15°C, otherwise extra thinner may be required to obtain application viscosity too much solvent results in reduced sag resistance 0 -10%, depending on required thickness and application conditions Marine Coatings

カタログの1ページ目を開く

Recommended thinner CLEANING SOLVENT SAFETY PRECAUTIONS ADDITIONAL DATA 0 -10%, depending on required thickness and application conditions for paint and recommended thinners see safety sheets 1430,1431 and relevant material safety data sheets this is a solvent borne paint and care should be taken to avoid inhalation of spray mist or vapour as well as contact between the wet paint and exposed skin Film thickness and spreading rate theoretical spreading rate m2/l 8.5 Worldwide availability Overcoating table for Sigma EcoFleet 238 A with itself for dft up to 125 urn 12 hours 8 hours 4 hours 2...

カタログの2ページ目を開く

The Information In this data sheet Is based upon laboratory tests we believe to be accurate and Is Intended for guidance only. All recommendations or suggestions relating to the use of the Sigma Coatings products made by PPG Protective & Marine Coatings, whether In technical documentation, or In response to a specific enquiry, or otherwise, are based on data which to the best of our knowledge are reliable. The products and Information are designed for users having the requisite knowledge and Industrial skills and It Is the end-user's responsibility to determine the suitability of the...

カタログの3ページ目を開く