Gelshield Plus
1 / 2ページ

カタログの抜粋

Gelshield Plus Solventless Epoxy for Osmosis Treatment Gelshield Plus is International's high build two-component solventless epoxy, formulated to offer effective treatment of Gelshield Plus is designed to allow short or long overcoating intervals. The new high- build formula enables at least 150 microns to be achieved per coat. Gelshield Plus is recommended for Gelshield centres and repair centres across Europe. Gelshield PLUS • Highly water-resistant. • Available in green and blue, which offer good contrast for overcoating with itself or over • Contains no harmful solvents to migrate into the hull and cause reblistehng. • Compatible with Epiglass® epoxy if a clear coat is preferred to visibly wet out glass fibres. • Wide overcoating window means wide range of work practices allowed. Cured polyester laminates and epoxy fillers PRODUCT DATA CONVERTER/CURING AGENT AVAILABLE SHADES PACK SIZE TYPICAL SHELF LIFE Refer to Gelshield Plus Product data sheet for more information Always read the Health & Safety precautions on the label prior to use Brush / Roller Green, Blue

カタログの1ページ目を開く

SURFACE PREPARATIONS AND SYSTEMS Osmosis Treatment: Gelcoat should be removed by blasting, or peeling plus a light blasting. The resultant substrate should be carefully examined and professionally evaluated as chemically dry. Surface must be clean and dry prior to application of Epiglass HT9000 or Gelshield Plus. Method: Apply initial coat with a thin film roller and work the surface using a brush. (Alternatively Epiglass can be used as the first coat in the scheme). Lay off with a brush making sure a minimum of 150 microns wet film thickness is applied. Fill as required using Intertill...

カタログの2ページ目を開く