カタログ >
International Marine >
INTERTUF 262 DATA SHEET

INTERTUF 262 DATA SHEET
1 / 4ページ

カタログの抜粋

PRODUCT DESCRIPTION A surface tolerant, two pack epoxy primer. Epoxy Anticorrosive INTENDED USES As an epoxy anticorrosive coating for use from Keel to Rail. Suitable for use with controlled cathodic protection. For use at Newbuilding, Maintenance & Repair or On Board Maintenance. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids Typical Film Thickness Theoretical Coverage Flash Point Induction Period 4.00 volume(s) Part A to 1 volume(s) Part B 234 ft2/US gal at 5 mils dft, allow appropriate loss factors Airless Spray, Brush, Roller Part A 82°F; Part B 93°F; Mixed 84°F None required Drying Information Overcoating Data - see limitations Substrate Temperature Note The overcoating data above for Interbond 201 applies to the Temperate version only. REGULATORY DATA 279 g/lt (2.33 lb/US gal) as supplied (EPA Method 24) 229 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings

カタログの1ページ目を開く

International "ÎSÎiE CERTIFICATION When used as part of an approved scheme, this material has the following certification: • Food Contact - Carriage of Grain (NOHA) • Fire Resistance - Surface Spread of Flame (WFR) - (IMO Resolution A653 (16)) • Fire Resistance - MSC61 (67) Smoke & Toxicity (WFR) • Fire Resistance - Marine Equipment Directive compliant • Food Contact - FDA Compliant: Dry Foodstuffs Consult your International Paint representative for details. SYSTEMS AND Consult your International Paint representative for the system best suited for the surfaces to be protected. SURFACE...

カタログの2ページ目を開く

Epoxy Anticorrosive Airless Spray Conventional Spray Work Stoppages and Cleanup Material is supplied in two containers as a unit. Always mix a complete unit in the portions supplied. Once the unit has been mixed it must be used within the working pot life specified. (1) Agitate Base (Part A) with power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Not recommended. Use International GTA220 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Total output fluid pressure...

カタログの3ページ目を開く

Epoxy Anticorrosive A system of Intertuf 262 followed by Intergard 263 may be used for the spot repair or upgrade of the following Spot Repair (Suitable Substrates): - Epoxy, Coal Tar Epoxy, Chlorinated Rubber, Vinyl Tar, Tar-free Vinyl Substrates not suitable for repair : - Bituminous Upgrade (Suitable Substrates): - Epoxy, Coal Tar Epoxy, Chlorinated Rubber Substrates not suitable for upgrading:- Vinyl Tar, Tar-free Vinyl, Bituminous Feathered overlap areas must be kept to a minimum. Overcoating information is given for guidance only and is subject to regional variation depending upon...

カタログの4ページ目を開く