カタログ >
International Marine >
Intersmooth 7670 SPC

Intersmooth 7670 SPC
1 / 4ページ

カタログの抜粋

Intersmooth 7670 SPC TBT Free, Low Friction, Self Polishing Copolymer A/F PRODUCT DESCRIPTION A high solids, high performance, TBT free, Copper free, Low friction, Self Polishing Copolymer (SPC) antifouling paint with patented copper acrylate copolymer. INTENDED USES Developed especially to meet the severe fouling challenge of vessels trading in coastal waters. Suitable for use on both coastal and deep sea vessels depending on activity profile and intended service life. For use at Newbuilding and Maintenance & Repair. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids Typical Film Thickness Range: 75 - 150 microns dry (132 - 263 microns wet) may be specified depending upon end use. Theoretical Coverage Range: 7.6 - 3.8 m²/litre at 75 - 150 microns dft, allow appropriate loss factors Airless Spray, Brush, Roller Flash Point (Typical) Drying Information Touch Dry [ISO 9117/3:2010] Before Flooding Note If any single coat dft >150μm or total dft is >300μm, the flooding times must be increased as follows: 48 hours at -5°C, 36 hours at 5°C, 24 hours at 25°C and 12 hours at 35°C. Overcoating Data - see limitations Substrate Temperature -5°C REGULATORY DATA Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances. This product does not contain organotin compounds acting as biocides and as such is in compliance with the International Convention on the Control of Harmful Anti-fouling Systems on ships as adopted by IMO in October 2001 (IMO document AFS/CONF/26). Marine Coatings Page 1 of 4 Issue Date:23/01/

カタログの1ページ目を開く

Intersmooth 7670 SPC TBT Free, Low Friction, Self Polishing Copolymer A/F CERTIFICATION When used as part of an approved scheme, this product has the following certification: Product recognised by the following classification societies as compliant with the International Convention on the Control of Harmful Anti-fouling Systems on Ships, 2001 (AFS 2001): • DNV GL • Lloyds Register Consult your local representative for details. Consult your local representative for the system best suited for the surfaces to be protected. SURFACE PREPARATIONS Use in accordance with the standard Worldwide...

カタログの2ページ目を開く

Intersmooth 7670 SPC TBT Free, Low Friction, Self Polishing Copolymer A/F APPLICATION Mixing This material is a one pack coating and should always be mixed thoroughly with a power agitator before application. Not Recommended. Use International GTA007 only in exceptional circumstances (max 5% by volume). DO NOT thin more than allowed by local environmental legislation. Airless Spray Recommended Tip Range 0.63-0.79 mm (25-31 thou) Total output fluid pressure at spray tip not less than 211 kg/cm² (3000 p.s.i.) Conventional Spray Application by conventional spray is not recommended. Application...

カタログの3ページ目を開く

Intersmooth 7670 SPC TBT Free, Low Friction, Self Polishing Copolymer A/F LIMITATIONS Do not expose the coated article for prolonged exposure to sunlight. Prolonged exposure to sunlight may affect the antifouling performance of the paint. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative for specific recommendations. Apply in good weather. Temperature of the surface to be coated must be at least 3°C above the dew point. For optimum...

カタログの4ページ目を開く