カタログ >
International Marine >
Intersleek 717

Intersleek 717
1 / 4ページ

カタログの抜粋

Intersleek 717 Link Coat PRODUCT DESCRIPTION A two pack foul release system link coat. INTENDED USES To enable application of the Intersleek 700 and Intersleek 900 Foul Release Systems over SPC antifoulings. For use at Maintenance & Repair. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids 2.50 volume(s) Part A to 1 volume(s) Part B Typical Film Thickness Theoretical Coverage 217 ft²/US gal at 4 mils dft, allow appropriate loss factors Airless Spray, Brush, Roller Flash Point Part A 108°F; Part B 88°F; Mixed 99°F Induction Period Drying Information Hard Dry [ISO 9117-1:2009] Pot Life Overcoating Data - see limitations Overcoated By Intersleek 731 Intersleek 737 Note REGULATORY DATA Substrate Temperature The minimum temperature at which Intersleek 717 may be overcoated with Intersleek 731 is 68°F, the minimum interval being 5 hours and the maximum 12 hours. * Refer to the Intersleek Application Guidelines for details on application of Intersleek 737 down to 32°F. 411 g/lt (3.43 lb/US gal) as supplied (EPA Method 24) 343 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) 373 g/lt Chinese National Standard GB23985 Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings Page 1 of 4 Issue Date:12/4/

カタログの1ページ目を開く

Intersleek 717 Link Coat SYSTEMS AND COMPATIBILITY Consult your International Paint representative for the system best suited for the surfaces to be protected. SURFACE PREPARATIONS Use in accordance with the standard Worldwide Marine Specifications. All surfaces to be coated should be clean, dry and free from contamination. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning. Intersleek 717 should always be applied over an approved antifouling and/or...

カタログの2ページ目を開く

Intersleek 717 Link Coat APPLICATION Mixing Material is supplied in two containers as a unit. Always mix a complete unit in the portions supplied. Once the unit has been mixed it must be used within the working pot life specified. (1) Agitate Base (Part A) with power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. International GTA220. Thinning is not normally required. Consult the local representative for advice during application in extreme conditions. Do not thin more than allowed by local environmental...

カタログの3ページ目を開く

Intersleek 717 Link Coat LIMITATIONS UNIT SIZE Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative for specific recommendations. Apply in good weather. Temperature of the surface to be coated must be at least 5°F above the dew point. For optimum application properties bring the material to 70°F-81°F, unless specifically instructed otherwise, prior to mixing and application. Unmixed material (in closed containers) should be maintained in...

カタログの4ページ目を開く