カタログ >
International Marine >
Intershield 300V

Intershield 300V
1 / 4ページ

カタログの抜粋

Intershield 300V Abrasion Resistant Aluminium Pure Epoxy PRODUCT DESCRIPTION A <340g/l VOC light coloured, abrasion resistant, aluminium pure epoxy coating giving excellent long term anticorrosive protection and low temperature application capability. INTENDED USES A universal primer which can be applied directly to mechanically prepared shop primer or suitably prepared bare steel. Suitable for use with controlled cathodic protection. A tank coating which is approved for the carriage of potable water. For use at Newbuilding or Maintenance & Repair. Certified to ANSI/NSF Standard 61. NSF Certification is for tanks greater than 5,000 gallons PRODUCT INFORMATION Part B (Curing Agent) Volume Solids 1.00 volume(s) Part A to 1 volume(s) Part B Typical Film Thickness Theoretical Coverage 4.2 m²/litre at 150 microns dft, allow appropriate loss factors Airless Spray, Brush, Roller Flash Point (Typical) Part A 41°C; Part B 26°C; Mixed 31°C Induction Period Drying Information Overcoating Data - see limitations Substrate Temperature Intershield 300V Immersed Areas Intershield 300V Non Immersed Areas¹ Intershield 6GV REGULATORY DATA For Intergard 740, Interthane 990 and Interthane 990HS a minimum temperature of 5°C is required to achieve full cure and specified performance. 1 For Intershield 300V - Non Immersed Areas, the maximum overcoating times are subject to inspection and evaluation. Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances. Marine Coatings Page 1 of 4 Issue Date

カタログの1ページ目を開く

Intershield 300V Abrasion Resistant Aluminium Pure Epoxy CERTIFICATION When used as part of an approved scheme, this product has the following certification: • • • • • Food Contact - Carriage of Grain (NOHA) Fire Resistance - Marine Equipment Directive compliant Fire Resistance - Surface Spread of Flame (Exova Warringtonfire) Fire Resistance - Smoke & Toxicity (Exova Warringtonfire) Potable Water - Certification for tanks greater than 5,000 gallons (ANSI Standard 61) Potable Water Certification issued by external bodies is dependent upon formulation and/or manufacturing site. Based on this,...

カタログの2ページ目を開く

Intershield 300V Abrasion Resistant Aluminium Pure Epoxy APPLICATION Mixing Material is supplied in 2 containers as a unit. Always mix a complete unit in the proportions supplied. Once the unit has been mixed it must be used within the working pot life specified. (1) Agitate Base (Part A) with a power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Use International GTA220 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Airless Spray Recommended Tip Range 0.48-0.64...

カタログの3ページ目を開く

Intershield 300V Abrasion Resistant Aluminium Pure Epoxy LIMITATIONS Intershield 300V should be high pressure fresh water washed and/or solvent washed prior to overcoating, where necessary, to ensure removal of any surface contamination that has accumulated. Suitable for use on tanker decks subject to Classification Society Regulations. Intershield 300V may be applied at substrate temperatures down to -5°C, however consideration should be given when overcoating at low temperatures as the remainder of the system may require higher temperatures to achieve full cure. For North America: if...

カタログの4ページ目を開く