カタログ >
International Marine >
INTERPRIME 198

INTERPRIME 198
1 / 4ページ

カタログの抜粋

Alkyd Primer PRODUCT DESCRIPTION INTENDED USES PRODUCT INFORMATION A quick drying, one pack primer. Interprime 198 is surface tolerant, compatible with most substrates and can be overcoated with a wide range of finishes. For the maintenance of above water areas. Approved for the carriage of grain when used as part of an approved For use at Maintenance & Repair or On Board Maintenance. Part B (Curing Agent) Volume Solids Typical Film Thickness Theoretical Coverage Flash Point 219 ft2/US gal at 3 mils dft, allow appropriate loss factors Airless Spray, Brush, Roller Drying Information Overcoating Data - see limitations Substrate Temperature REGULATORY DATA 506 g/lt (4.22 lb/US gal) as supplied (EPA Method 24) 416 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings

カタログの1ページ目を開く

CERTIFICATION When used as part of an approved scheme, this material has the following certification: • Fire Resistance - Surface Spread of Flame (WFR) - (IMO Resolution A653 (16)) • Fire Resistance - Surface Spread of Flame (Korean Register of Shipping) • Fire Resistance - MSC61 (67) Smoke & Toxicity (WFR) • Food Contact - Carriage of Grain (NOHA) • Fire Resistance - Marine Equipment Directive compliant Consult your International Paint representative for details. SYSTEMS AND Consult your International Paint representative for the system best suited for the surfaces to be protected. SURFACE...

カタログの2ページ目を開く

Alkyd Primer This material is a one pack coating and should always be mixed thoroughly with a power agitator before Not recommended. Use International GTA007 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Total output fluid pressure at spray tip not less than 2500 psi (176 kg/cm2) Application by conventional spray is not recommended. Recommended. Multiple coats may be required to achieve specified dft. Recommended. Multiple coats may be required to achieve specified dft. Work Stoppages and Cleanup Thoroughly flush all equipment with...

カタログの3ページ目を開く

Alkyd Primer It is recommended that Interprime 198 is not overcoated with epoxy coatings. In certain regions, for specific customer requests and where cosmetic properties are not of concern, Interprime 198 may be applied without a cosmetic finish. Consult your regional technical centre for guidelines and details of colors Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative for specific recommendations. Apply in good weather. Temperature of the...

カタログの4ページ目を開く